Re: [PATCH 4/4] iio: magnetometer: ak8975: modernize polling loops with iopoll() macros

[Andy Shevchenko <andriy.shevchenko@intel.com>]

On Mon, Apr 20, 2026 at 11:08:04AM +0000, Joshua Crofts wrote:
> The driver currently uses while loops and msleep() for polling during
> conversion waits.
> 
> Replace the custom polling loops with readx_poll_timeout() and
> read_poll_timeout() macros from <linux/iopoll.h>. This reduces
> boilerplate, standardizes timeout handling and improves overall code
> readability, keeping the original timing and error behaviour.

...

>  	/* Wait for the conversion to complete. */
> -	while (timeout_ms) {
> -		msleep(AK8975_CONVERSION_DONE_POLL_TIME);
> -		if (gpiod_get_value(data->eoc_gpiod))
> -			break;
> -		timeout_ms -= AK8975_CONVERSION_DONE_POLL_TIME;
> -	}
> -	if (!timeout_ms) {
> +	ret = readx_poll_timeout(gpiod_get_value, data->eoc_gpiod, val, val != 0,

' != 0' is not needed, but perhaps okay in this case to explicitly hint that
this is used as boolean conditional.

> +							 AK8975_CONVERSION_DONE_POLL_TIME * 1000,
> +							 AK8975_MAX_CONVERSION_TIMEOUT * 1000);

Somebody broke the indentation...

> +

...and added unneeded blank line.

Also, use multipliers from time.h, id est USEC_PER_MSEC.

> +	if (ret) {
>  		dev_err(&client->dev, "Conversion timeout happened\n");
>  		return -EINVAL;
>  	}

...

>  static int wait_conversion_complete_polled(struct ak8975_data *data)

Same comments as per above.

-- 
With Best Regards,
Andy Shevchenko