Re: Question regarding SAS controllers.

[Justin Piszcz <jpiszcz@lucidpixels.com>]

On Sat, 22 Nov 2008, Dr. David Alan Gilbert wrote:

> * Justin Piszcz (jpiszcz@lucidpixels.com) wrote:
>
> <snip>
>
>> Eric,
>>
>> Thanks, I had checked this out earlier but the only non-raid SAS HBAs
>> (those HBAs that do not end in -R) that are JBOD seem to be external only
>> (e.g., do not contain any internal SAS ports?)
>>
>> Justin.
>
> For some of the SAS cards that LSI produce there are 2 sets of firmware
> on their site and you can load the non-RAID firmware; both versions
> will let you drive stuff as individual drives (e.g. tape drives or
> inidivudal discs) but the non-RAID firmware is a LOT faster for that.

Four and eight port LSI cards:
http://www.lsi.com/storage_home/products_home/host_bus_adapters/sas_hbas/lsisas3041er/index.html
http://www.lsi.com/storage_home/products_home/host_bus_adapters/sas_hbas/lsisas3081er/index.html

Firmware and BIOS for both Integrated RAID and Initiator-Target.  Must 
boot to DOS to run utility.  Batch file simplifies installation.

Welcome to LSI Logic Integrated SAS Flash Utility
      This Utility will upgrade your LSI SAS3442E HBA

      Integrated RAID ( IR ) or Initiator ( IT ) Firmware

     For IR     Type   R or r
     For IT     Type   T or t
     To Exit    Type   q

So one just needs to flash the card and use the initiator firmware and 
then it will act like a regular (SAS) HBA, no RAID in the card itself, and 
then one, presumably could use the card for md/software raid and have 
direct access to the disks, no need for exporting disks via JBOD etc?

Justin.