From: Linus Torvalds <torvalds@linux-foundation.org>
To: "Alejandro Riveira Fernández" <ariveira@gmail.com>
Cc: "linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
linux-wireless@vger.kernel.org
Subject: Re: Linux 2.6.26-rc4
Date: Wed, 28 May 2008 13:10:39 -0700 (PDT) [thread overview]
Message-ID: <alpine.LFD.1.10.0805281307150.2958@woody.linux-foundation.org> (raw)
In-Reply-To: <20080527124315.131b1343@Varda>
On Tue, 27 May 2008, Alejandro Riveira Fernández wrote:
>
> Compiled and booting into 2.6.26-rc4
>
> 1) With splash quiet on grub line it doesn't boot (or i didin't wait long
> enough)
> 2) without quiet and splash I get into VT X filas becouse i use the evil
> nvidia driver that's expected. But ubuntu failsafe mode (xserver with vesa
> in low res) doesn't show up either *regression*
Can you give more details about where it stops?
> 3) i get an oops with network manager
.. again, please give the full oops, without that we just know that "an
oops happened".
> 4) if i try to run some sudo command it gets stuck (Crtl +C doesnt' help)
> "ip route" gets stuck too. User programs i tried wrok fine (only ls and
> htop). Network realted problem?
I assume it's related to the oops above - the oops probably happened while
holding some mutex or other lock, which is why network-related stuff then
blocks on that lock (which will never be released, since the oops killed
the process that held it).
I suspect the oops is also why the bootup breaks, so it's likely all the
same issue. Please save the dmesg into a file, reboot into a working
setup, and send that. Along with hw information (it's likely related to
your network device driver, since I've not seen an uproar of these kinds
of problems from everybody else..).
> 5) printk times on dmesg go crazy
More details, please, again.
Linus
next prev parent reply other threads:[~2008-05-28 20:10 UTC|newest]
Thread overview: 89+ messages / expand[flat|nested] mbox.gz Atom feed top
2008-05-26 18:41 Linus Torvalds
2008-05-26 21:24 ` Jesper Krogh
2008-05-26 21:42 ` Linus Torvalds
2008-05-27 0:25 ` Arjan van de Ven
2008-05-27 0:31 ` Arjan van de Ven
2008-05-27 5:43 ` David Woodhouse
2008-05-27 6:00 ` Arjan van de Ven
2008-05-27 6:24 ` David Woodhouse
2008-05-27 1:16 ` Carl-Daniel Hailfinger
2008-05-27 1:23 ` Carl-Daniel Hailfinger
2008-05-27 1:52 ` Abhijit Menon-Sen
2008-05-27 5:19 ` Jesper Krogh
2008-05-27 5:31 ` [MTD] [MAPS] ck804rom: fix driver_data in probe table David Woodhouse
2008-05-27 5:31 ` Linux 2.6.26-rc4 David Woodhouse
2008-05-27 10:35 ` Jeff Garzik
2008-05-27 10:53 ` Carl-Daniel Hailfinger
2008-05-27 10:54 ` Jeff Garzik
2008-05-27 10:58 ` Carl-Daniel Hailfinger
2008-05-27 5:23 ` 2.6.26-rc4: RIP find_pid_ns+0x6b/0xa0 Alexey Dobriyan
2008-05-27 9:06 ` Oleg Nesterov
2008-05-27 15:03 ` Linus Torvalds
2008-05-27 15:40 ` Paul E. McKenney
2008-05-27 16:11 ` Linus Torvalds
2008-05-27 17:06 ` Paul E. McKenney
2008-05-28 5:01 ` Paul E. McKenney
2008-05-28 7:26 ` Paul E. McKenney
2008-05-27 16:45 ` Oleg Nesterov
2008-05-27 17:37 ` Oleg Nesterov
2008-05-27 21:26 ` Alexey Dobriyan
2008-05-27 10:01 ` Linux 2.6.26-rc4 J.A. Magallón
2008-05-28 23:59 ` Bill Davidsen
[not found] ` <20080527124315.131b1343@Varda>
2008-05-28 20:10 ` Linus Torvalds [this message]
2008-05-28 20:17 ` Johannes Berg
2008-05-28 21:48 ` John W. Linville
2008-06-03 9:49 ` Jesper Krogh
2008-06-03 9:57 ` Al Viro
2008-06-03 10:04 ` Jesper Krogh
2008-06-03 10:13 ` Miklos Szeredi
2008-06-03 10:37 ` Miklos Szeredi
2008-06-03 10:48 ` Al Viro
2008-06-03 13:31 ` Ian Kent
2008-06-03 13:32 ` Ian Kent
2008-06-03 10:40 ` Al Viro
2008-06-03 10:45 ` Miklos Szeredi
2008-06-03 10:52 ` Al Viro
2008-06-03 13:27 ` Ian Kent
2008-06-03 15:01 ` Linus Torvalds
2008-06-03 16:07 ` Ian Kent
2008-06-03 16:35 ` Linus Torvalds
2008-06-03 16:41 ` Al Viro
2008-06-03 16:50 ` Al Viro
2008-06-03 17:28 ` Ian Kent
2008-06-03 17:41 ` Al Viro
2008-06-03 17:41 ` Ian Kent
2008-06-03 17:50 ` Al Viro
2008-06-03 17:49 ` Ian Kent
2008-06-03 16:59 ` Linus Torvalds
2008-06-03 17:30 ` Ian Kent
2008-06-03 17:13 ` Ian Kent
2008-06-03 17:30 ` Al Viro
2008-06-03 17:38 ` Ian Kent
2008-06-03 17:46 ` Jeff Moyer
2008-06-03 19:18 ` Al Viro
2008-06-03 19:53 ` Jeff Moyer
2008-06-03 23:00 ` Al Viro
2008-06-04 2:42 ` Ian Kent
2008-06-04 5:34 ` Miklos Szeredi
2008-06-04 5:41 ` Ian Kent
2008-06-10 4:57 ` Ian Kent
2008-06-10 6:28 ` Jesper Krogh
2008-06-10 6:40 ` Ian Kent
2008-06-10 9:09 ` Ian Kent
2008-06-12 3:03 ` Ian Kent
2008-06-12 7:02 ` Jesper Krogh
2008-06-12 11:21 ` Ian Kent
2008-06-12 11:19 ` Ian Kent
2008-06-04 1:36 ` Ian Kent
2008-06-05 7:31 ` Ian Kent
2008-06-05 21:29 ` Linus Torvalds
2008-06-05 21:34 ` Jesper Krogh
2008-06-06 2:39 ` Ian Kent
2008-06-05 22:30 ` Andrew Morton
2008-06-06 2:47 ` Ian Kent
2008-06-27 4:18 ` Ian Kent
2008-06-06 6:23 ` Jesper Krogh
2008-06-06 8:21 ` Ian Kent
2008-06-06 8:25 ` Ian Kent
2008-06-03 10:35 ` Al Viro
2008-06-04 17:51 ` Jesper Krogh
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=alpine.LFD.1.10.0805281307150.2958@woody.linux-foundation.org \
--to=torvalds@linux-foundation.org \
--cc=ariveira@gmail.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-wireless@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®