From: Hugh Dickins <hughd@google.com>
To: Andrew Morton <akpm@linux-foundation.org>
Cc: Linus Torvalds <torvalds@linux-foundation.org>,
Matthew Wilcox <willy@infradead.org>,
Song Liu <songliubraving@fb.com>,
"Kirill A. Shutemov" <kirill.shutemov@linux.intel.com>,
Yang Shi <yang.shi@linux.alibaba.com>,
Denis Lisov <dennis.lissov@gmail.com>, Qian Cai <cai@lca.pw>,
Suren Baghdasaryan <surenb@google.com>,
David Rientjes <rientjes@google.com>,
Minchan Kim <minchan@kernel.org>,
linux-kernel@vger.kernel.org, linux-mm@kvack.org
Subject: [PATCH] mm/khugepaged: fix filemap page_to_pgoff(page) != offset
Date: Fri, 9 Oct 2020 20:07:59 -0700 (PDT) [thread overview]
Message-ID: <alpine.LSU.2.11.2010091943300.13335@eggly.anvils> (raw)
There have been elusive reports of filemap_fault() hitting its
VM_BUG_ON_PAGE(page_to_pgoff(page) != offset, page) on kernels built
with CONFIG_READ_ONLY_THP_FOR_FS=y.
Suren has hit it on a kernel with CONFIG_READ_ONLY_THP_FOR_FS=y and
CONFIG_NUMA is not set: and he has analyzed it down to how khugepaged
without NUMA reuses the same huge page after collapse_file() failed
(whereas NUMA targets its allocation to the respective node each time).
And most of us were usually testing with CONFIG_NUMA=y kernels.
collapse_file(old start)
new_page = khugepaged_alloc_page(hpage)
__SetPageLocked(new_page)
new_page->index = start // hpage->index=old offset
new_page->mapping = mapping
xas_store(&xas, new_page)
filemap_fault
page = find_get_page(mapping, offset)
// if offset falls inside hpage then
// compound_head(page) == hpage
lock_page_maybe_drop_mmap()
__lock_page(page)
// collapse fails
xas_store(&xas, old page)
new_page->mapping = NULL
unlock_page(new_page)
collapse_file(new start)
new_page = khugepaged_alloc_page(hpage)
__SetPageLocked(new_page)
new_page->index = start // hpage->index=new offset
new_page->mapping = mapping // mapping becomes valid again
// since compound_head(page) == hpage
// page_to_pgoff(page) got changed
VM_BUG_ON_PAGE(page_to_pgoff(page) != offset)
An initial patch replaced __SetPageLocked() by lock_page(), which did
fix the race which Suren illustrates above. But testing showed that it's
not good enough: if the racing task's __lock_page() gets delayed long
after its find_get_page(), then it may follow collapse_file(new start)'s
successful final unlock_page(), and crash on the same VM_BUG_ON_PAGE.
It could be fixed by relaxing filemap_fault()'s VM_BUG_ON_PAGE to a
check and retry (as is done for mapping), with similar relaxations in
find_lock_entry() and pagecache_get_page(): but it's not obvious what
else might get caught out; and khugepaged non-NUMA appears to be unique
in exposing a page to page cache, then revoking, without going through
a full cycle of freeing before reuse.
Instead, non-NUMA khugepaged_prealloc_page() release the old page
if anyone else has a reference to it (1% of cases when I tested).
Although never reported on huge tmpfs, I believe its find_lock_entry()
has been at similar risk; but huge tmpfs does not rely on khugepaged
for its normal working nearly so much as READ_ONLY_THP_FOR_FS does.
Reported-by: Denis Lisov <dennis.lissov@gmail.com>
Bugzilla: https://bugzilla.kernel.org/show_bug.cgi?id=206569
Link: https://lore.kernel.org/linux-mm/?q=20200219144635.3b7417145de19b65f258c943%40linux-foundation.org
Reported-by: Qian Cai <cai@lca.pw>
Link: https://lore.kernel.org/linux-xfs/?q=20200616013309.GB815%40lca.pw
Reported-and-analyzed-by: Suren Baghdasaryan <surenb@google.com>
Fixes: 87c460a0bded ("mm/khugepaged: collapse_shmem() without freezing new_page")
Signed-off-by: Hugh Dickins <hughd@google.com>
Cc: stable@vger.kernel.org # v4.9+
---
mm/khugepaged.c | 12 ++++++++++++
1 file changed, 12 insertions(+)
--- 5.9-rc8/mm/khugepaged.c 2020-09-06 17:34:46.939306972 -0700
+++ linux/mm/khugepaged.c 2020-10-08 16:19:42.999765534 -0700
@@ -914,6 +914,18 @@ static struct page *khugepaged_alloc_hug
static bool khugepaged_prealloc_page(struct page **hpage, bool *wait)
{
+ /*
+ * If the hpage allocated earlier was briefly exposed in page cache
+ * before collapse_file() failed, it is possible that racing lookups
+ * have not yet completed, and would then be unpleasantly surprised by
+ * finding the hpage reused for the same mapping at a different offset.
+ * Just release the previous allocation if there is any danger of that.
+ */
+ if (*hpage && page_count(*hpage) > 1) {
+ put_page(*hpage);
+ *hpage = NULL;
+ }
+
if (!*hpage)
*hpage = khugepaged_alloc_hugepage(wait);
next reply other threads:[~2020-10-10 3:27 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-10-10 3:07 Hugh Dickins [this message]
2020-10-10 15:09 ` Matthew Wilcox
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=alpine.LSU.2.11.2010091943300.13335@eggly.anvils \
--to=hughd@google.com \
--cc=akpm@linux-foundation.org \
--cc=cai@lca.pw \
--cc=dennis.lissov@gmail.com \
--cc=kirill.shutemov@linux.intel.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mm@kvack.org \
--cc=minchan@kernel.org \
--cc=rientjes@google.com \
--cc=songliubraving@fb.com \
--cc=surenb@google.com \
--cc=torvalds@linux-foundation.org \
--cc=willy@infradead.org \
--cc=yang.shi@linux.alibaba.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®