From: Andreas Hartmann <andihartmann@freenet.de>
To: linux-kernel@vger.kernel.org
Subject: Ongoing problems with sis900.c in 2.4.20pre11
Date: Thu, 24 Oct 2002 19:53:06 +0200 [thread overview]
Message-ID: <ap9c23$1cb$1@ID-44327.news.dfncis.de> (raw)
Hello all,
though the new bug fix for Tx timeout from Mufasa Yang in Rev 1.08.06, the
problem is not fixed at all. The problem appeares now not quite often as
before.
I can find the following logentries in /var/log/messages:
Oct 24 19:40:25 susi kernel: eth0: Media Link Off
Oct 24 19:40:35 susi kernel: eth0: Media Link On 100mbps full-duplex
Oct 24 19:40:36 susi kernel: eth0: Media Link Off
Oct 24 19:40:46 susi kernel: eth0: Media Link On 100mbps full-duplex
Oct 24 19:40:47 susi kernel: eth0: Media Link Off
Oct 24 19:40:57 susi kernel: eth0: Media Link On 100mbps full-duplex
Oct 24 19:40:58 susi kernel: eth0: Media Link Off
Oct 24 19:41:07 susi kernel: NETDEV WATCHDOG: eth0: transmit timed out
Oct 24 19:41:07 susi kernel: eth0: Transmit timeout, status 00000004
00000000
Oct 24 19:41:08 susi kernel: eth0: Media Link On 100mbps full-duplex
Oct 24 19:41:09 susi kernel: eth0: Media Link Off
Oct 24 19:41:18 susi kernel: NETDEV WATCHDOG: eth0: transmit timed out
Oct 24 19:41:18 susi kernel: eth0: Transmit timeout, status 00000004
00000040
Oct 24 19:41:19 susi kernel: eth0: Media Link On 100mbps full-duplex
Oct 24 19:41:20 susi kernel: eth0: Media Link Off
Oct 24 19:41:30 susi kernel: eth0: Media Link On 100mbps full-duplex
The problem occures between two sis900-cards (see lspci). You can fix it by
restarting the network on one of the two machines (including rmmod sis900).
00:00.0 Host bridge: Acer Laboratories Inc. [ALi] M1541 (rev 04)
Subsystem: Acer Laboratories Inc. [ALi] ALI M1541 Aladdin V/V+ AGP
System Controller
Flags: bus master, slow devsel, latency 64
Memory at e6000000 (32-bit, non-prefetchable) [size=16M]
Capabilities: [b0] AGP version 1.0
00:01.0 PCI bridge: Acer Laboratories Inc. [ALi] M5243 (rev 04) (prog-if 00
[Normal decode])
Flags: bus master, slow devsel, latency 64
Bus: primary=00, secondary=01, subordinate=01, sec-latency=64
I/O behind bridge: 0000d000-0000dfff
Memory behind bridge: e4800000-e5ffffff
Prefetchable memory behind bridge: e7f00000-e7ffffff
00:03.0 Bridge: Acer Laboratories Inc. [ALi] M7101 PMU
Subsystem: Acer Laboratories Inc. [ALi] ALI M7101 Power Management
Controller
Flags: medium devsel
00:07.0 ISA bridge: Acer Laboratories Inc. [ALi] M1533 PCI to ISA Bridge
[Aladdin IV] (rev c3)
Flags: bus master, medium devsel, latency 0
00:0a.0 Multimedia audio controller: Xilinx, Inc. RME Digi96
Flags: slow devsel, IRQ 12
Memory at e3000000 (32-bit, non-prefetchable) [size=16M]
00:0b.0 Ethernet controller: Silicon Integrated Systems [SiS] SiS900 10/100
Ethernet (rev 02)
Subsystem: Silicon Integrated Systems [SiS] SiS900 10/100 Ethernet
Adapter
Flags: bus master, medium devsel, latency 32, IRQ 10
I/O ports at b800 [size=256]
Memory at e2800000 (32-bit, non-prefetchable) [size=4K]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [40] Power Management version 1
00:0f.0 IDE interface: Acer Laboratories Inc. [ALi] M5229 IDE (rev c1)
(prog-if 8a [Master SecP PriP])
Flags: bus master, medium devsel, latency 32
I/O ports at b400 [size=16]
01:00.0 VGA compatible controller: ATI Technologies Inc 3D Rage Pro AGP
1X/2X (rev 5c) (prog-if 00 [VGA])
Subsystem: ATI Technologies Inc: Unknown device 0084
Flags: bus master, stepping, medium devsel, latency 64, IRQ 11
Memory at e5000000 (32-bit, non-prefetchable) [size=16M]
I/O ports at d800 [size=256]
Memory at e4800000 (32-bit, non-prefetchable) [size=4K]
Expansion ROM at e7fe0000 [disabled] [size=128K]
Capabilities: [50] AGP version 1.0
I would be very happy if this very old problem could be really fixed.
Regards,
Andreas Hartmann
next reply other threads:[~2002-10-24 17:43 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2002-10-24 17:53 Andreas Hartmann [this message]
[not found] ` <1157976531.20030127174314@alum.mit.edu>
2003-01-28 17:41 ` Andreas Hartmann
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to='ap9c23$1cb$1@ID-44327.news.dfncis.de' \
--to=andihartmann@freenet.de \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®