Re: [PATCH v5 2/2] media: i2c: mira016: Add driver for Mira016

[Sakari Ailus <sakari.ailus@linux.intel.com>]

Hi Jacopo,

On Wed, Sep 30, 2026 at 12:51:20PM +0200, Jacopo Mondi wrote:
> Add driver for the ams OSRAM Mira016 sensor.
> 
> Signed-off-by: Jacopo Mondi <jacopo.mondi@ideasonboard.com>
> +static int mira016_parse_endpoint(struct device *dev, struct mira016 *mira016)
> +{
> +	struct fwnode_handle *endpoint __free(fwnode_handle) = NULL;
> +	struct v4l2_fwnode_endpoint ep_cfg = {
> +		.bus_type = V4L2_MBUS_CSI2_DPHY
> +	};
> +	int ret;
> +
> +	endpoint = fwnode_graph_get_endpoint_by_id(dev_fwnode(dev), 0, 0, 0);
> +	if (!endpoint)
> +		return -ENODEV;
> +
> +	ret = v4l2_fwnode_endpoint_alloc_parse(endpoint, &ep_cfg);
> +	if (ret)
> +		return ret;
> +
> +	/*
> +	 * Link frequencies: the driver supports a single link frequency,
> +	 * no need to check bitmap after this call.
> +	 */
> +	ret = v4l2_link_freq_to_bitmap(dev, ep_cfg.link_frequencies,
> +				       ep_cfg.nr_of_link_frequencies,
> +				       mira016_link_freqs,
> +				       ARRAY_SIZE(mira016_link_freqs),
> +				       &mira016->link_freq_bitmap);
> +	if (ret) {
> +		v4l2_fwnode_endpoint_free(&ep_cfg);

I recall commenting about this at in least three occasions earlier.

Also applies to the other driver.

> +		return ret;
> +	}
> +
> +	/* TODO: Implement D-PHY configuration to support continuous clock. */
> +	if (!(ep_cfg.bus.mipi_csi2.flags & V4L2_MBUS_CSI2_NONCONTINUOUS_CLOCK)) {
> +		dev_err(dev, "Continuous clock is not supported\n");
> +		v4l2_fwnode_endpoint_free(&ep_cfg);
> +		return -EINVAL;
> +	}
> +
> +	mira016->bus_config = ep_cfg.bus.mipi_csi2.flags;
> +
> +	v4l2_fwnode_endpoint_free(&ep_cfg);
> +
> +	return 0;
> +}

-- 
Regards,

Sakari Ailus