[PATCH] tpm: clean up error checking in setup_ring()

[Dan Carpenter <error27@gmail.com>]

The bind_evtchn_to_irqhandler() function can never return 0.
Historically, IRQ functions used to return zero on error, but then we
added an architecture where that was a valid IRQ so it went from being
an error to being success (but in a limitted way, just enough for that
arch to boot, I guess).  Eventually we removed it and we will never
allow zero to be a valid IRQ again.

The problem here is that if zero were an invalid IRQ then we should
return a negative error code but the code returns zero/success.

Change the code to check for negative error codes so it's not question
of how the zero should be handled.

Signed-off-by: Dan Carpenter <error27@gmail.com>
---
From static analysis.  Untested.

 drivers/char/tpm/xen-tpmfront.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/char/tpm/xen-tpmfront.c b/drivers/char/tpm/xen-tpmfront.c
index 3c0cce57c4ae..731444eac5f2 100644
--- a/drivers/char/tpm/xen-tpmfront.c
+++ b/drivers/char/tpm/xen-tpmfront.c
@@ -266,7 +266,7 @@ static int setup_ring(struct xenbus_device *dev, struct tpm_private *priv)
 
 	rv = bind_evtchn_to_irqhandler(priv->evtchn, tpmif_interrupt, 0,
 				       "tpmif", priv);
-	if (rv <= 0) {
+	if (rv < 0) {
 		xenbus_dev_fatal(dev, rv, "allocating TPM irq");
 		return rv;
 	}
-- 
2.53.0