Re: [PATCH v2 RESEND] iio: accel: adxl345: update period cache after successful write

[Andy Shevchenko <andriy.shevchenko@intel.com>]

On Sun, Oct 18, 2026 at 09:42:00PM +0800, Wenqiang Zhao via B4 Relay wrote:
> 
> The ADXL345 event-period read path returns st->inact_time_ms. The setters
> for inactivity, free-fall and the ODR-derived default currently update
> this cache before writing TIME_INACT or TIME_FF. If the regmap write
> fails, the sysfs write reports an error but a subsequent read returns
> the requested period even though it was not programmed.
> 
> Update the cached period only after the corresponding regmap write
> succeeds.

...

>  	/* Inactivity time in s */
> -	return regmap_write(st->regmap, ADXL345_REG_TIME_INACT, val);
> +	ret = regmap_write(st->regmap, ADXL345_REG_TIME_INACT, val);
> +	if (ret)
> +		return ret;
> +
> +	st->inact_time_ms = MILLI * val;

While at it, replace MILLI with MSEC_PER_SEC (from time.h).

> +	return 0;

...

>  static int adxl345_set_inactivity_time(struct adxl345_state *st, u32 val_int)
>  {
> +	int ret;
> +
> +	ret = regmap_write(st->regmap, ADXL345_REG_TIME_INACT, val_int);
> +	if (ret)
> +		return ret;
> +
>  	st->inact_time_ms = MILLI * val_int;

Ditto.

> -	return regmap_write(st->regmap, ADXL345_REG_TIME_INACT, val_int);
> +	return 0;
>  }

...

>  static int adxl345_set_freefall_time(struct adxl345_state *st, u32 val_fract)
>  {
> +	int ret;
> +
>  	/*
>  	 * Datasheet max. value is 255 * 5000 us = 1.275000 seconds.
>  	 *
>  	 * Recommended values between 100ms and 350ms (0x14 to 0x46)
>  	 */
> +	ret = regmap_write(st->regmap, ADXL345_REG_TIME_FF,
> +			   DIV_ROUND_CLOSEST(val_fract, 5));
> +	if (ret)
> +		return ret;
> +
>  	st->inact_time_ms = DIV_ROUND_UP(val_fract, MILLI);

Hmm... Okay, since it's three instances and only one you actually touched
perhaps a separate patch.

> -	return regmap_write(st->regmap, ADXL345_REG_TIME_FF,
> -			    DIV_ROUND_CLOSEST(val_fract, 5));
> +	return 0;
>  }

-- 
With Best Regards,
Andy Shevchenko