On Fri, Oct 16, 2026 at 06:05:21PM +0800, Jiale Yao wrote: > regulator_disable_deferred() schedules hardware access after a > caller-provided delay. The power-efficient system workqueue remains > active during system suspend, so deferred regulator operations can reach > a bus after its controller has been suspended. > Use the freezable power-efficient workqueue to preserve the existing > power policy while deferring regulator access until devices have resumed. This is going to have a fun interaction with the only current user of deferred disables, DAPM. If a DAPM supply that uses deferred disables is active at system suspend then it will disable it using a deferred disable but since the workqueue is frozen quite early on in suspend this will simply result in the disable not happening until after the suspend has completed which isn't the desired outcome. Since if we're suspending it's reasonable to assume that the supply won't be bounced on again quickly, or that if it is we can reasonably pay the cost of full ramp up, we should probably arrange for the disable to be processed immeditely if we're in suspend. In addition if there are already pending disables it'd make sense to flush them rather than letting the workqueue freeze, for similar reasons.