Re: [PATCH RFC] arm64: dts: qcom: nord: add ADC-TM thermistor channels for Nord PMICs

[Shawn Guo <shengchao.guo@oss.qualcomm.com>]

On Fri, Oct 30, 2026 at 10:28:21AM +0100, Bartosz Golaszewski wrote:
> On Wed, Oct 28, 2026 at 11:01:03PM +0800, Shawn Guo wrote:
> > From: Dhruvin Rajpura <dhruvin.rajpura@oss.qualcomm.com>
> > 
> > PMAU0102 (Kai_MV) and PMM8650AU's Kobra_MM ADC5 Gen3 controllers only
> > expose REF_GND/1P25VREF/DIE_TEMP calibration channels; none of their
> > AMUX thermistor pins are wired up, so none of the board thermistor
> > rails feed the thermal framework.
> > 
> > Only 3 AMUX pins are actually wired to thermistors on Nord, all on
> > Kai and none on Kobra: Kai instance E's AMUX1 (SDRAM3 THERM) and Kai
> > instance I's AMUX1/AMUX2 (SDRAM1 THERM, UFS THERM). Kai's other AMUX
> > pins are either DO_NOT_USE or wired to voltage-rail monitors, not
> > thermistors, so add only these 3 channels.
> > 
> > Add #thermal-sensor-cells = <1> to the two Kai adc@ nodes that gain
> > a channel, the new AMUX1[/AMUX2]_THM channel(s) with qcom,adc-tm,
> > and a per-channel thermal-zone for each, following the existing
> > Gen3/Gen4 board pattern of a direct thermal-sensors phandle into the
> > ADC channel.
> > 
> > Signed-off-by: Dhruvin Rajpura <dhruvin.rajpura@oss.qualcomm.com>
> > Signed-off-by: Shawn Guo <shengchao.guo@oss.qualcomm.com>
> > ---
> 
> ...
> 
> > +
> >  		pmau0102_f_thermal: pmau0102-f-thermal {
> >  			polling-delay-passive = <100>;
> >  			thermal-sensors = <&pmau0102_f_mbg_temp>;
> > @@ -501,6 +545,42 @@ trip0 {
> >  			};
> >  		};
> >  
> > +		pmau0102_i_sdram1_thermal: pm-i-sdram1-thermal {
> 
> Existing thermal zone nodes use the "pmau0102" prefix.

Indeed! I will update to to be consistent.

> With that:
> 
> Acked-by: Bartosz Golaszewski <bartosz.golaszewski@oss.qualcomm.com>

Thanks Bartosz!

Shawn