Re: [PATCH 6/8] i2c: nomadik: handle pm_runtime errors

[Wolfram Sang <wsa+renesas@sang-engineering.com>]

On Thu, Nov 05, 2026 at 09:42:02AM +0100, Linus Walleij wrote:
> On Tue, Nov 3, 2026 at 9:30 AM Dmitry Guzman <Dmitry.Guzman@mobileye.com> wrote:
> 
> > In nmk_i2c_xfer(), pm_runtime_get_sync() is called on start and then
> > the controller registers are accessed without checking the return value.
> > If pm_runtime_get_sync() fails, access to the register of the device that
> > was not correctly powered on may cause a bus fault or other unpredictable
> > system behavior.
> >
> > Check the return value of pm_runtime_get_sync() and it if is not 0,
> > return the error immediately.
> >
> > Signed-off-by: Dmitry Guzman <Dmitry.Guzman@mobileye.com>
> (...)
> > -       pm_runtime_get_sync(&priv->adev->dev);
> > +       i = pm_runtime_get_sync(&priv->adev->dev);
> > +       if (i)
> > +               return i;
> 
> It's a bit odd to reuse the i (= iterator...) variable for this.
> I would just add an int ret or int err for this.

Yes, please.