Re: [PATCH v2] hwmon: (pmbus/bel-pfe) Enable PMBUS_SKIP_STATUS_CHECK for pfe1100

[Guenter Roeck <linux@roeck-us.net>]

On Fri, Aug 04, 2023 at 03:14:03PM -0700, rentao.bupt@gmail.com wrote:
> From: Tao Ren <rentao.bupt@gmail.com>
> 
> Skip status check for both pfe1100 and pfe3000 because the communication
> error is also observed on pfe1100 devices.
> 
> Signed-off-by: Tao Ren <rentao.bupt@gmail.com>

Applied.

Thanks,
Guenter

> ---
>  Changes in v2:
>    - improving comments.
>    - removing unnecessary {}
> 
>  drivers/hwmon/pmbus/bel-pfe.c | 16 ++++++++--------
>  1 file changed, 8 insertions(+), 8 deletions(-)
> 
> diff --git a/drivers/hwmon/pmbus/bel-pfe.c b/drivers/hwmon/pmbus/bel-pfe.c
> index fa5070ae26bc..7c5f4b10a7c1 100644
> --- a/drivers/hwmon/pmbus/bel-pfe.c
> +++ b/drivers/hwmon/pmbus/bel-pfe.c
> @@ -17,12 +17,13 @@
>  enum chips {pfe1100, pfe3000};
>  
>  /*
> - * Disable status check for pfe3000 devices, because some devices report
> - * communication error (invalid command) for VOUT_MODE command (0x20)
> - * although correct VOUT_MODE (0x16) is returned: it leads to incorrect
> - * exponent in linear mode.
> + * Disable status check because some devices report communication error
> + * (invalid command) for VOUT_MODE command (0x20) although the correct
> + * VOUT_MODE (0x16) is returned: it leads to incorrect exponent in linear
> + * mode.
> + * This affects both pfe3000 and pfe1100.
>   */
> -static struct pmbus_platform_data pfe3000_plat_data = {
> +static struct pmbus_platform_data pfe_plat_data = {
>  	.flags = PMBUS_SKIP_STATUS_CHECK,
>  };
>  
> @@ -94,16 +95,15 @@ static int pfe_pmbus_probe(struct i2c_client *client)
>  	int model;
>  
>  	model = (int)i2c_match_id(pfe_device_id, client)->driver_data;
> +	client->dev.platform_data = &pfe_plat_data;
>  
>  	/*
>  	 * PFE3000-12-069RA devices may not stay in page 0 during device
>  	 * probe which leads to probe failure (read status word failed).
>  	 * So let's set the device to page 0 at the beginning.
>  	 */
> -	if (model == pfe3000) {
> -		client->dev.platform_data = &pfe3000_plat_data;
> +	if (model == pfe3000)
>  		i2c_smbus_write_byte_data(client, PMBUS_PAGE, 0);
> -	}
>  
>  	return pmbus_do_probe(client, &pfe_driver_info[model]);
>  }