Re: [PATCH v3 2/4] arm64: defconfig: Enable Glymur configs for boot to shell

[Pankaj Patil <pankaj.patil@oss.qualcomm.com>]

On 12/20/2025 10:47 PM, Dmitry Baryshkov wrote:
> On Fri, Dec 19, 2025 at 08:16:55PM +0530, Pankaj Patil wrote:
>> The serial engine must be properly setup before kernel reaches
>> "init",so UART driver and its dependencies needs to be built in.
>> Enable its dependency clocks,interconnect and pinctrl as built-in
>> to boot Glymur CRD board to UART console with rootfs on nvme storage.
>> DISPCC enabled as module, used for display.
>>
>> Signed-off-by: Pankaj Patil <pankaj.patil@oss.qualcomm.com>
>> ---
>>  arch/arm64/configs/defconfig | 5 +++++
>>  1 file changed, 5 insertions(+)
>>
>> @@ -1425,6 +1426,9 @@ CONFIG_COMMON_CLK_MT8192_SCP_ADSP=y
>>  CONFIG_COMMON_CLK_MT8192_VDECSYS=y
>>  CONFIG_COMMON_CLK_MT8192_VENCSYS=y
>>  CONFIG_COMMON_CLK_QCOM=y
>> +CONFIG_CLK_GLYMUR_DISPCC=m
>> +CONFIG_CLK_GLYMUR_GCC=y
>> +CONFIG_CLK_GLYMUR_TCSRCC=y
> Is TCSRCC also required for serial?

Not required for serial, will update to m in next rev

>
>>  CONFIG_CLK_X1E80100_CAMCC=m
>>  CONFIG_CLK_X1E80100_DISPCC=m
>>  CONFIG_CLK_X1E80100_GCC=y