Re: [PATCH v4 3/3] arm64: dts: qcom: eliza-evk: Add PCIe1 with TC9563 PCIe switch

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 7/28/26 9:06 AM, Krishna Chaitanya Chundru wrote:
> The Eliza EVK board connects PCIe1 (8GT/s x2) to a Toshiba TC9563
> PCIe switch. Enable PCIe1 and its QMP PHY nodes.
> 
> TC9563 uses I2C (at address 0x77 on I2C4) for its management interface.
> 
> Override the base iommu-map with the expanded set covering all the
> switch's downstream ports (0x1400-0x1408 SID range).
> 
> The TC9563 RESX# and PERST# are OR-ed internally to assert reset on the
> switch. Use TC9563 RESX# pin via a TLMM GPIO and skip wiring PERST#
> from the PCIe controller.
> 
> Signed-off-by: Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>
> ---

[...]

> +			reg = <0x21800 0x0 0x0 0x0 0x0>;
> +			#address-cells = <3>;
> +			#size-cells = <2>;
> +			device_type = "pci";
> +			ranges;
> +			bus-range = <0x5 0xff>;
> +
> +			pci@0,0 {

FWIW these subnodes should be pcie@ too

Konrad

> +				reg = <0x50000 0x0 0x0 0x0 0x0>;
> +				#address-cells = <3>;
> +				#size-cells = <2>;
> +				device_type = "pci";
> +				ranges;
> +			};
> +
> +			pci@0,1 {
> +				reg = <0x50100 0x0 0x0 0x0 0x0>;
> +				#address-cells = <3>;
> +				#size-cells = <2>;
> +				device_type = "pci";
> +				ranges;
> +			};
> +		};
> +	};
> +};
> +
>  &uart13 {
>  	compatible = "qcom,geni-debug-uart";
>  
> diff --git a/arch/arm64/boot/dts/qcom/eliza.dtsi b/arch/arm64/boot/dts/qcom/eliza.dtsi
> index c99bcccae00c..2ecfeddea496 100644
> --- a/arch/arm64/boot/dts/qcom/eliza.dtsi
> +++ b/arch/arm64/boot/dts/qcom/eliza.dtsi
> @@ -2104,6 +2104,7 @@ opp-16000000-3 {
>  			};
>  
>  			pcie1_port0: pcie@0 {
> +				compatible = "pciclass,0604";
>  				device_type = "pci";
>  				reg = <0x0 0x0 0x0 0x0 0x0>;
>  				bus-range = <0x01 0xff>;
>