Re: [PATCH v2 3/5] [RFT] ARM: dts: wheat: Fix ADV7513 address usage

[Lars-Peter Clausen <lars@metafoo.de>]

On 02/12/2018 07:11 PM, Kieran Bingham wrote:
[...]
> +	/*
> +	 * The adv75xx resets its addresses to defaults during low power power
> +	 * mode. Because we have two ADV7513 devices on the same bus, we must
> +	 * change both of them away from the defaults so that they do not
> +	 * conflict.
> +	 */
>  	hdmi@3d {
>  		compatible = "adi,adv7513";
> -		reg = <0x3d>;
> +		reg = <0x3d 0x2d 0x4d, 0x5d>;

To have the correct semantics this should be:
		reg = <0x3d>, <0x2d>, <0x4d>, <0x5d>;

It is a set of 4 single cell addresses. The other thing is a single 4 cell
address. It will get compiled to the same bytes, but the DT tools should
complain about it, because it doesn't match #address-cells.

> +		reg-names = "main", "cec", "edid", "packet";
>  
>  		adi,input-depth = <8>;
>  		adi,input-colorspace = "rgb";
> @@ -272,7 +279,8 @@
>  
>  	hdmi@39 {
>  		compatible = "adi,adv7513";
> -		reg = <0x39>;
> +		reg = <0x39 0x29 0x49, 0x59>;

Same here.

> +		reg-names = "main", "cec", "edid", "packet";
>  
>  		adi,input-depth = <8>;
>  		adi,input-colorspace = "rgb";
>