Re: [PATCH v7 05/10] tpm, tpm_tis: Only handle supported interrupts

[Lino Sanfilippo <LinoSanfilippo@gmx.de>]

Hi Jason,

On 26.08.22 at 19:43, Jason Andryuk wrote:
> On Wed, Jun 29, 2022 at 7:28 PM Lino Sanfilippo <LinoSanfilippo@gmx.de> wrote:
>
>> @@ -1007,8 +1029,39 @@ int tpm_tis_core_init(struct device *dev, struct tpm_tis_data *priv, int irq,
>>         if (rc < 0)
>>                 goto out_err;
>>
>> -       intmask |= TPM_INTF_CMD_READY_INT | TPM_INTF_LOCALITY_CHANGE_INT |
>> -                  TPM_INTF_DATA_AVAIL_INT | TPM_INTF_STS_VALID_INT;
>> +       /* Figure out the capabilities */
>> +       rc = tpm_tis_read32(priv, TPM_INTF_CAPS(priv->locality), &intfcaps);
>> +       if (rc < 0)
>> +               goto out_err;
>> +
>> +       dev_dbg(dev, "TPM interface capabilities (0x%x):\n",
>> +               intfcaps);
>> +       if (intfcaps & TPM_INTF_BURST_COUNT_STATIC)
>> +               dev_dbg(dev, "\tBurst Count Static\n");
>> +       if (intfcaps & TPM_INTF_CMD_READY_INT) {
>> +               intmask |= TPM_INTF_CMD_READY_INT;
>> +               dev_dbg(dev, "\tCommand Ready Int Support\n");
>> +       }
>> +       if (intfcaps & TPM_INTF_INT_EDGE_FALLING)
>> +               dev_dbg(dev, "\tInterrupt Edge Falling\n");
>> +       if (intfcaps & TPM_INTF_INT_EDGE_RISING)
>> +               dev_dbg(dev, "\tInterrupt Edge Rising\n");
>> +       if (intfcaps & TPM_INTF_INT_LEVEL_LOW)
>> +               dev_dbg(dev, "\tInterrupt Level Low\n");
>> +       if (intfcaps & TPM_INTF_INT_LEVEL_HIGH)
>> +               dev_dbg(dev, "\tInterrupt Level High\n");
>> +       if (intfcaps & TPM_INTF_LOCALITY_CHANGE_INT)
>
> Hi, you may already have fixed this, but I just saw:
>
> error: this ‘if’ clause does not guard... [-Werror=misleading-indentation]
>  1144 |         if (intfcaps & TPM_INTF_LOCALITY_CHANGE_INT)
>       |         ^~
>
>> +               intmask |= TPM_INTF_LOCALITY_CHANGE_INT;
>> +               dev_dbg(dev, "\tLocality Change Int Support\n");
>
> You need { } for the block.
>

Thanks for pointing at this. I will fix it in the next version of the series.

Best Regards,
Lino


> Regards,
> Jason
>