Re: [PATCH v3] usb: xhci: add LWP quirk for ensuring uPD720201 into D3 state after S5

[zhuyinbo <zhuyinbo@loongson.cn>]

在 2021/11/11 下午2:28, Yinbo Zhu 写道:
> After S5, any pci device should into D3 state that if supported, but the
> uPD720201 was not and cause OSPM power consumption is more higher that
> S5 than S4. Due to that uPD720201 firmware behavior was unknown and the
> _PS3 method wasn't implemented in ACPI table which can make device into
> D3, I think xhci HCD can add a quirk ensure it into D3 state after S5
> that is appropriate and this patch was to add the XHCI_LWP_QURIK and set
> PCI_D3hot to uPD720201 pmsc register in xhci_pci_shutdown and
> xhci_pci_remove to fix xhci power consumption issue.
>
> Signed-off-by: Yinbo Zhu <zhuyinbo@loongson.cn>
> ---
> Change in v3:
> 		Add D3 set in xhci_pci_remove function.
>
>   drivers/usb/host/xhci-pci.c | 9 +++++++++
>   drivers/usb/host/xhci.h     | 1 +
>   2 files changed, 10 insertions(+)
>
> diff --git a/drivers/usb/host/xhci-pci.c b/drivers/usb/host/xhci-pci.c
> index 2c9f25c..6258a5a 100644
> --- a/drivers/usb/host/xhci-pci.c
> +++ b/drivers/usb/host/xhci-pci.c
> @@ -265,6 +265,7 @@ static void xhci_pci_quirks(struct device *dev, struct xhci_hcd *xhci)
>   	    pdev->device == 0x0014) {
>   		xhci->quirks |= XHCI_TRUST_TX_LENGTH;
>   		xhci->quirks |= XHCI_ZERO_64B_REGS;
> +		xhci->quirks |= XHCI_LWP_QUIRK;
>   	}
>   	if (pdev->vendor == PCI_VENDOR_ID_RENESAS &&
>   	    pdev->device == 0x0015) {
> @@ -466,6 +467,10 @@ static void xhci_pci_remove(struct pci_dev *dev)
>   		pci_set_power_state(dev, PCI_D3hot);
>   
>   	usb_hcd_pci_remove(dev);
> +
> +	/* Workaround for decreasing power consumption after S5 */
> +	if (xhci->quirks & XHCI_LWP_QUIRK)
> +		pci_set_power_state(dev, PCI_D3hot);
>   }
>   
>   #ifdef CONFIG_PM
> @@ -610,6 +615,10 @@ static void xhci_pci_shutdown(struct usb_hcd *hcd)
>   	/* Yet another workaround for spurious wakeups at shutdown with HSW */
>   	if (xhci->quirks & XHCI_SPURIOUS_WAKEUP)
>   		pci_set_power_state(pdev, PCI_D3hot);
> +
> +	/* Workaround for decreasing power consumption after S5 */
> +	if (xhci->quirks & XHCI_LWP_QUIRK)
> +		pci_set_power_state(pdev, PCI_D3hot);
>   }
>   #endif /* CONFIG_PM */
>   
> diff --git a/drivers/usb/host/xhci.h b/drivers/usb/host/xhci.h
> index dca6181..bcd70d1 100644
> --- a/drivers/usb/host/xhci.h
> +++ b/drivers/usb/host/xhci.h
> @@ -1899,6 +1899,7 @@ struct xhci_hcd {
>   #define XHCI_SG_TRB_CACHE_SIZE_QUIRK	BIT_ULL(39)
>   #define XHCI_NO_SOFT_RETRY	BIT_ULL(40)
>   #define XHCI_BROKEN_D3COLD	BIT_ULL(41)
> +#define XHCI_LWP_QUIRK		BIT_ULL(42)
>   
>   	unsigned int		num_active_eps;
>   	unsigned int		limit_active_eps;

Hi all,


Do you have any advice about my patch, if no any question, please you 
help me merge this patch to upstream.


Thanks,

BRs,

Yinbo Zhu.