Re: [PATCH v3 1/6] dt-bindings: iio: adc: ad7768-1: Document multidevice support

[David Lechner <dlechner@baylibre.com>]

On 8/18/26 1:46 AM, Krzysztof Kozlowski wrote:
> On 18/08/2026 01:32, Jonathan Santos wrote:
>> The AD7768-1 family supports aggregating up to four devices on a single
>> SPI controller, with each device occupying a dedicated CS line and a
>> single data lane.
>>
>> Extend the `reg` property to accept up to 4 entries (one per device).
>>
>> Add `spi-rx-bus-width` property to declare the per-device lane count.
>> Since each lane is bound to one CS, the number of entries must match
>> `reg`. Make it required when `reg` has more than one entry.
>>
>> Add an example for a four ADAQ7768-1 aggregation, with shared DRDY and
>> SYNC_IN pin.
>>
>> Signed-off-by: Jonathan Santos <Jonathan.Santos@analog.com>
>> ---
>> Changes in v3:
>> * New patch.
> 
> Please use scripts/get_maintainers.pl to get a list of necessary people
> and lists to CC. It might happen, that command when run on an older
> kernel, gives you outdated entries. Therefore please be sure you base
> your patches on recent Linux kernel.
> 
> Tools like b4 or scripts/get_maintainer.pl provide you proper list of
> people, so fix your workflow. Tools might also fail if you work on some
> ancient tree (don't, instead use mainline) or work on fork of kernel
> (don't, instead use mainline). Just use b4 and everything should be
> fine, although remember about `b4 prep --auto-to-cc` if you added new
> patches to the patchset.
> 
> You missed at least devicetree list (maybe more), so this won't be

Also missed IIO.

> tested by automated tooling. Performing review on untested code might be
> a waste of time.
> 
> Please kindly resend and include all necessary To/Cc entries.
> 
> Best regards,
> Krzysztof