Re: [PATCH v2 0/3] arm64: boot: dts: ti: k3-am62l: allow WKUP UART wakeup from LPM

[Kendall Willis <k-willis@ti.com>]

On 1/7/26 10:45, Bryan Brattlof wrote:
> On January  6, 2026 thus sayeth Kendall Willis:
>> K3 TI AM62L SoC supports wakeup from WKUP UART when the SoC is in the
>> DeepSleep low power mode. To allow wakeup from WKUP UART the target-module
>> device tree node is enabled. The ti-sysc interconnect target module driver
>> is used to configure the the SYSCONFIG related registers. In this case,
>> the interconnect target module node configures the WKUP UART to be able to
>> wakeup from system suspend. The SYSC register is used to enable wakeup
>> from system suspend for the WKUP UART. Refer to 14.7.2.5 UART in the
>> AM62L Techincal Reference Manual for registers referenced [1].
>>
>> Previous TI SoCs configure the WKUP UART to wakeup from system suspend
>> using the ti-sysc interconnect target module driver. Refer to commit
>> ce27f7f9e328 ("arm64: dts: ti: k3-am62-wakeup: Configure ti-sysc for
>> wkup_uart0") for an example of this.
> 
> I think I may be confused. What is setting the pinmux for the wkup_uart
> to allow us to trigger the wake event? It looks like they reset to GPIO
> pins if not set. Is firmware doing this?

On AM62L, the WKUP UART pinmux is initially set by TFA so that it is set 
to the UART pins, not GPIO. The target-module node sets the WKUP UART 
SYSC register so that wakeup is enabled.

Best,
Kendall

> 
> ~Bryan