Re: [PATCH v2 13/15] ARM: dts: milbeaut: Add device tree set for the Milbeaut M10V board

["Sugaya, Taichi" <sugaya.taichi@socionext.com>]

Hi,

On 2019/02/19 19:11, Arnd Bergmann wrote:
> On Tue, Feb 19, 2019 at 6:11 AM Sugaya, Taichi
> <sugaya.taichi@socionext.com> wrote:
>>
>> Hi,
>> Thank you for you comments.
>>
>> On 2019/02/18 21:09, Arnd Bergmann wrote:
>>> On Fri, Feb 8, 2019 at 1:28 PM Sugaya Taichi
>>> <sugaya.taichi@socionext.com> wrote:
>>>> +
>>>> +       aliases {
>>>> +               serial1 = &uart1;
>>>> +       };
>>>
>>> Maybe start with serial0 here? It seems unusual to start
>>> counting at 1.
>>>
>>
>> The M10V evaluation board(EVB) uses a console with uart ch1, so this
>> alias number is derived from the used channel one.
>> Therefore it is no problem to change the alias number to 0.
> 
> The alias should normally reflect whatever is printed on the board,
> if there are no labels, the convention is to start with zero, regardless
> of what internal uart is connected to it.
> 

I got it.
I use a "serial0" beacause there are no labels about uart ch on M10V EVB.

Thanks,
Sugaya Taichi

>       Arnd
>