Re: [PATCH 2/2] misc: pci_endpoint_test: Set reserved BARs for each SoCs

[Kunihiko Hayashi <hayashi.kunihiko@socionext.com>]

Hi Niklas,

On 2024/12/23 21:05, Niklas Cassel wrote:
> On Mon, Dec 23, 2024 at 08:51:42PM +0900, Kunihiko Hayashi wrote:
>> On 2024/12/19 22:08, Niklas Cassel wrote:
>>> On Thu, Dec 19, 2024 at 08:17:50PM +0900, Kunihiko Hayashi wrote:
>>>> On 2024/12/17 17:19, Niklas Cassel wrote:
> 
> [...]
> 
>> On the other hand, some other SoCs might have BAR masks fixed by the DWC
>> IP configuration. These BARs will be exposed to the host even if the BAR
>> mask is set to 0. However, such case hasn't been upstreamed, so there is
>> no need to worry about them now.
> 
> The three schemes are:
> BARn_SIZING_SCHEME_N =“Fixed Mask” (0)
> BARn_SIZING_SCHEME_N =“Programmable Mask” (1)
> BARn_SIZING_SCHEME_N =“Resizable BAR” (2)
> 
> Considering that the text:
> "To disable a BAR (in any of the three schemes), your application can
> write ‘0’ to the LSB of the BAR mask register."
> 
> says "in any of the three schemes", I would expect writing 0 to BAR_MASK
> should disable a BAR, even for a Fixed Mask/Fixed BAR.
The behavior in my case seemed suspicious "in any of the three schemes",
so I investigated and found it was an issue with specifying dbi2
address.

I confirmed disabing a BAR with writing 0 to the BAR mask.

Thank you for your explanation.
Again, this patch [2/2] will be withdrawn, and I expect that the
condition of the test and endpoint BAR reset for am654 will be fixed.

Thank you,

---
Best Regards
Kunihiko Hayashi