On Wed, 2026-07-01 at 17:14 +0200, Krzysztof Kozlowski wrote: > On 01/07/2026 15:25, Markus Probst wrote: > > > > + > > > > +maintainers: > > > > + - Alexandre Belloni > > > > > > This should be someone caring about this hardware. > > He does have the majority of commits on this driver (excluding merge > > commits and commits not exclusive to this driver), although most of > > them are pretty tiny. > > > > Who would you suggest instead? > > Someone adding features for this driver, maybe driver maintainers. But > if Alexandre is fine, you can leave him. > > > > > > > > + > > > > +description: > > > > + The S-35390A is a CMOS 2-wire real-time clock IC which operates with the > > > > + very low current consumption in the wide range of operation voltage. > > > > + > > > > +allOf: > > > > + - $ref: rtc.yaml# > > > > + > > > > +properties: > > > > + compatible: > > > > + const: sii,s35390a > > > > + > > > > + reg: > > > > + maxItems: 1 > > > > + > > > > + sii,wakealarm-output-pin: > > > > + $ref: /schemas/types.yaml#/definitions/uint32 > > > > + enum: [1, 2] > > > > + description: | > > > > + The output pin to wake up the system. > > > > + Default will use the output pin for interrupt signal 2. > > > > + : Output pin for interrupt signal 1 > > > > + : Output pin for interrupt signal 2 > > > > > > Does that mean device generates the interrupts? > > Yes. > > > > > Then I think you miss interrupts property. From what I can tell the line is used to generate a system wakeup event. There would be no obvious benefit of connecting it to an interrupt controller, so this property would be obsolete? Thanks - Markus Probst > > Best regards, > Krzysztof