Re: [PATCH v5 6/7] serial: omap: do not override settings for RS485 support

[Lino Sanfilippo <LinoSanfilippo@gmx.de>]

On 13.12.23 11:26, Ilpo Järvinen wrote:
> On Sat, 9 Dec 2023, Lino Sanfilippo wrote:
>
>> In serial_omap_rs485() RS485 support may be deactivated due to a missing
>
> There's no serial_omap_rs485() function. I assume/know you meant
> serial_omap_probe_rs485() but please correct.
>

Right, I meant serial_omap_probe_rs485(). Will fix the misnaming as well as
the typos below.

>> RTS GPIO. This is done by nullifying the ports rs485_supported struct.
>> After that however the serial_omap_rs485_supported struct is assigned to
>> the same structure unconditionally, which results in an unintended
>> reactivation of RS485 support.
>>
>> Fix this by callling serial_omap_rs485() after the assignment of
>
> callling -> calling.
>
> Again, the function name is incorrect.
>

>> rs485_supported.
>
> Wouldn't it be better if all rs485 init/setups would occur in the same
> place rather than being spread around? That is, move the rs485_config and
> rs485_supported setup into serial_omap_probe_rs485()?
>

No problem, I can do that. Thanks for the review(s)!

Regards,
Lino