I have two different systems with Blackmagic Design Intensity Pro-4K cards. One uses an ECS H81H3-I motherboard and the other uses a Gigabyte GA-H110N motherboard. Previously both were working properly. When I upgraded the Blackmagic Design desktopvideo package from version 10.7 to version 10.8 it included an update of the firmware on the cards from version 0x85 to 0xbd. After the upgrade the Gigabyte-motherboard system continues to work properly, but the ECS-motherboard system no longer shows the motherboard ethernet controller with lspci. Downgrading the firmware makes the ethernet controller reappear with lspci. Upgrading again makes it disappear again. Attached are the output of lscpi -vv for each version of the firmware on the ECS-motherboard system. Upgrading to the most recent ECS-motherboard bios did not have any effect. There are a number of differences in the two lspci outputs but based on conversations I've seen on LKM, which I peruse but am not subscribed to, I suspect that this is the important one: lspci-Intensity-Pro-4K-10.7-firmware.txt: Region 0: Memory at f7d00000 (32-bit, non-prefetchable) [size=1M] lspci-Intensity-Pro-4K-10.8-firmware.txt: Region 0: Memory at f7c00000 (64-bit, non-prefetchable) [size=1M] The Engineers at Blackmagic Design have confirmed that the change to a 64-bit BAR with firmware version 0xbd was intentional and correct. And to be clear, the Blackmagic cards continue to work properly. The issue is the motherboard ethernet controller disappearing after upgrading the Blackmagic cards to new firmware with a 64-bit BAR. Note, however, that 64-bit BAR is below 4GB with the high four bytes being all zeros. After the firmware update it's like there is "no room at the inn" for the motherboard ethernet controller so it never gets enabled. I think we can all agree that it's a likely a problem with the PC motherboard bios. I'm hoping to find a workaround to allow me to configure a number of existing ECS-motherboard systems in the field for use with the new firmware. I normally run Ubuntu 14.04 LTS and tried the most recent 4.4.0-38 kernel but then I noticed that the Ubuntu 16.10 daily build ISO switched to kernel 4.8-RC-something on Sept 21st. So I booted that livedvd and tried it to see if 4.8-RC included some recent PCIe 32-bit/64-bit resource fix but sadly the results were the same. With firmware 0xbd, the ethernet controller was still missing from the lspci output. I poked around with various of the kernel pci= parameters such as bios and nobios to no avail, but I really am out of my depth here. I'm available to run tests if anyone has any suggestions. Steve Kenton