Re: [PATCH 2/3] docs: hwmon: Add support for ina2xx

[Guenter Roeck <linux@roeck-us.net>]

On 2/24/20 3:26 PM, Franz Forstmayr wrote:
> Add documentation for INA260, power/current monitor with I2C interface.
> 

Subject should match description here (this patch does not add support
for ina2xx).

> Signed-off-by: Franz Forstmayr <forstmayr.franz@gmail.com>
> ---
>   Documentation/hwmon/ina2xx.rst | 19 ++++++++++++++++---
>   1 file changed, 16 insertions(+), 3 deletions(-)
> 
> diff --git a/Documentation/hwmon/ina2xx.rst b/Documentation/hwmon/ina2xx.rst
> index 94b9a260c518..74267dd433dd 100644
> --- a/Documentation/hwmon/ina2xx.rst
> +++ b/Documentation/hwmon/ina2xx.rst
> @@ -53,6 +53,16 @@ Supported chips:
>   
>   	       http://www.ti.com/
>   
> +  * Texas Instruments INA260
> +
> +    Prefix: 'ina260'
> +
> +    Addresses: I2C 0x40 - 0x4f
> +
> +    Datasheet: Publicly available at the Texas Instruments website
> +
> +         http://www.ti.com/
> +
>   Author: Lothar Felten <lothar.felten@gmail.com>
>   
>   Description
> @@ -72,14 +82,17 @@ INA230 and INA231 are high or low side current shunt and power monitors
>   with an I2C interface. The chips monitor both a shunt voltage drop and
>   bus supply voltage.
>   
> +INA260 is a high or low side current and power monitor with an integrated
> +shunt and I2C interface.
> +
>   The shunt value in micro-ohms can be set via platform data or device tree at
>   compile-time or via the shunt_resistor attribute in sysfs at run-time. Please
>   refer to the Documentation/devicetree/bindings/hwmon/ina2xx.txt for bindings
>   if the device tree is used.
>   
> -Additionally ina226 supports update_interval attribute as described in
> -Documentation/hwmon/sysfs-interface.rst. Internally the interval is the sum of
> -bus and shunt voltage conversion times multiplied by the averaging rate. We
> +Additionally ina226 and ina260 supports update_interval attribute as described

s/supports/support/

> +in Documentation/hwmon/sysfs-interface.rst. Internally the interval is the sum
> +of bus and shunt voltage conversion times multiplied by the averaging rate. We
>   don't touch the conversion times and only modify the number of averages. The
>   lower limit of the update_interval is 2 ms, the upper limit is 2253 ms.
>   The actual programmed interval may vary from the desired value.
>