Re: [PATCH v3 2/8] PCI: Replace msleep with fsleep for precise secondary bus reset

[Hans Zhang <18255117159@163.com>]

On 2025/8/27 07:05, Bjorn Helgaas wrote:
> On Wed, Aug 27, 2025 at 01:03:09AM +0800, Hans Zhang wrote:
>> The msleep() function with small values (less than 20ms) may not sleep
>> for the exact duration due to the kernel's timer wheel design. According
>> to the comment in kernel/time/sleep_timeout.c:
>>
>>    "The slack of timers which will end up in level 0 depends on sleep
>>    duration (msecs) and HZ configuration. For example, with HZ=1000 and
>>    a requested sleep of 2ms, the slack can be as high as 50% (1ms) because
>>    the minimum slack is 12.5% but the actual calculation for level 0 timers
>>    is slack = MSECS_PER_TICK / msecs. This means that msleep(2) can
>>    actually take up to 3ms (2ms + 1ms) on a system with HZ=1000."
> 
> I thought I heard something about 20ms being the minimum actual delay
> for small msleeps.  I suppose the error is larger for HZ=100 systems.
> 

Yes.

> The fsleep() would turn into something between 2ms and 2.5ms, so if
> we're talking about reducing 3ms to 2.5ms, I have a hard time getting
> worried about that.
> 
> And we're going to wait at least 100ms before touching the device
> below the bridge anyway.

int pci_bridge_secondary_bus_reset(struct pci_dev *dev)
	pcibios_reset_secondary_bus(dev);
                 pci_reset_secondary_bus(dev);
                         pci_read_config_word(dev, PCI_BRIDGE_CONTROL, 
&ctrl);
                         ctrl |= PCI_BRIDGE_CTL_BUS_RESET;
                         pci_write_config_word(dev, PCI_BRIDGE_CONTROL, 
ctrl);

                         /*
                         * PCI spec v3.0 7.6.4.2 requires minimum Trst 
of 1ms.  Double
                         * this to 2ms to ensure that we meet the 
minimum requirement.
                         */
                         msleep(2);      // As you mentioned, is it 
necessary to be very precise here? Please decide whether you want to 
make the modification.

                         ctrl &= ~PCI_BRIDGE_CTL_BUS_RESET;
                         pci_write_config_word(dev, PCI_BRIDGE_CONTROL, 
ctrl);
	pci_bridge_wait_for_secondary_bus(dev, "bus reset");
                 // There are also some delays in between.

                 // The delay here is also long enough.
                 pci_dev_wait(child, reset_type, 
PCIE_RESET_READY_POLL_MS - delay);




If it's not necessary to do so, do I still need to resubmit the version? 
Or do you choose a few acceptable ones or the first patch?



Best regards,
Hans

> 
>> This unnecessary delay can impact system responsiveness during PCI
>> operations, especially since the PCIe r7.0 specification, section
>> 7.5.1.3.13, requires only a minimum Trst of 1ms. We double this to 2ms
>> to ensure we meet the minimum requirement, but using msleep(2) may
>> actually wait longer than needed.
>>
>> Using fsleep() provides a more precise delay that matches the stated
>> intent of the code. The fsleep() function uses high-resolution timers
>> where available to achieve microsecond precision.
>>
>> Replace msleep(2 * PCI_T_RST_SEC_BUS_DELAY_MS) with
>> fsleep(2 * PCI_T_RST_SEC_BUS_DELAY_US) to ensure the actual delay is
>> closer to the intended 2ms delay.
>>
>> Signed-off-by: Hans Zhang <18255117159@163.com>
>> ---
>>   drivers/pci/pci.c | 2 +-
>>   drivers/pci/pci.h | 2 +-
>>   2 files changed, 2 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c
>> index c05a4c2fa643..81105dfc2f62 100644
>> --- a/drivers/pci/pci.c
>> +++ b/drivers/pci/pci.c
>> @@ -4964,7 +4964,7 @@ void pci_reset_secondary_bus(struct pci_dev *dev)
>>   	pci_write_config_word(dev, PCI_BRIDGE_CONTROL, ctrl);
>>   
>>   	/* Double this to 2ms to ensure that we meet the minimum requirement */
>> -	msleep(2 * PCI_T_RST_SEC_BUS_DELAY_MS);
>> +	fsleep(2 * PCI_T_RST_SEC_BUS_DELAY_US);
>>   
>>   	ctrl &= ~PCI_BRIDGE_CTL_BUS_RESET;
>>   	pci_write_config_word(dev, PCI_BRIDGE_CONTROL, ctrl);
>> diff --git a/drivers/pci/pci.h b/drivers/pci/pci.h
>> index 4d7e9c3f3453..9d38ef26c6a9 100644
>> --- a/drivers/pci/pci.h
>> +++ b/drivers/pci/pci.h
>> @@ -61,7 +61,7 @@ struct pcie_tlp_log;
>>   #define PCIE_LINK_WAIT_SLEEP_MS		90
>>   
>>   /* PCIe r7.0, sec 7.5.1.3.13, requires minimum Trst of 1ms */
>> -#define PCI_T_RST_SEC_BUS_DELAY_MS	1
>> +#define PCI_T_RST_SEC_BUS_DELAY_US	1000
>>   
>>   /* Message Routing (r[2:0]); PCIe r6.0, sec 2.2.8 */
>>   #define PCIE_MSG_TYPE_R_RC	0
>> -- 
>> 2.25.1
>>