Re: [PATCH RESEND 0/4] hwmon: (sch56xx) Automatically load on supported hardware

[Hans de Goede <hdegoede@redhat.com>]

Hi Armin,

On 1/31/22 10:37, Armin Wolf wrote:
> The hardware monitoring solutions supported by the sch5627 and
> sch5636 drivers are Fujitsu-specific.
> After some online searching, i found out that the solution used
> with the SCH5627 is called "Antiope" by Fujitsu, just like the
> "Theseus" solution inside the SCH5636.
> I also found out that "Antiope" and "Theseus" are listed as
> DMI onboard devices on supported Fujitsu devices, so the
> sch56xx_common module can be loaded automatically an check
> for the DMI devices. However some devices like the Esprimo C700
> have both devices, so after verifying that at least one onboard
> device is present, sch56xx_common still has to detect which chip
> is present.
> This is safe however if at least one device is present.
> 
> Tested on a Fujitsu Esprimo P720.
> 
> Armin Wolf (4):
>   hwmon: (sch56xx) Autoload modules on platform device creation
>   hwmon: (sch56xx-common) Add automatic module loading on supported
>     devices
>   hwmon: (sch56xx-common) Replace msleep() with usleep_range()
>   hwmon: (sch56xx-common) Replace WDOG_ACTIVE with WDOG_HW_RUNNING

Not sure why you did a resend? I received the original just fine ?

With that said the entire series looks good to me:

Reviewed-by: Hans de Goede <hdegoede@redhat.com>

for the series.

Regards,

Hans

> 
>  drivers/hwmon/sch5627.c        |  9 +++++++
>  drivers/hwmon/sch5636.c        |  9 +++++++
>  drivers/hwmon/sch56xx-common.c | 44 ++++++++++++++++++++++++++++++----
>  3 files changed, 58 insertions(+), 4 deletions(-)
> 
> --
> 2.30.2
>