mirror of https://lore.kernel.org/lkml/
 help / color / mirror / Atom feed
From: "Mantas M." <grawity@gmail.com>
To: linux-kernel@vger.kernel.org
Subject: Re: 3.3.1 ath9k regression
Date: Wed, 04 Apr 2012 13:40:39 +0300	[thread overview]
Message-ID: <jlh8eg$gqs$1@dough.gmane.org> (raw)
In-Reply-To: <4F7A8EB7.4060200@silka.with-linux.com>

[Kelly - use `journalctl -a` or just `dmesg` to get full logs.]

I have a similar bug with Atheros AR9285 on a ASUS K52JT laptop. The
device appears, but refuses to connect to any AP, timing out in less
than a second. (3.3-ARCH did not have this bug.)

dmesg output while trying to connect to an open AP follows.

> # modprobe ath9k
> [  213.662569] ath: EEPROM regdomain: 0x60
> [  213.662574] ath: EEPROM indicates we should expect a direct regpair map
> [  213.662580] ath: Country alpha2 being used: 00
> [  213.662583] ath: Regpair used: 0x60
> [  213.664533] ieee80211 phy1: Selected rate control algorithm 'ath9k_rate_control'
> [  213.666228] Registered led device: ath9k-phy1
> [  213.666255] ieee80211 phy1: Atheros AR9285 Rev:2 mem=0xffffc90022d60000, irq=17

> # ip link set wlan0 up
> [  215.577316] ADDRCONF(NETDEV_UP): wlan0: link is not ready

> # iw wlan0 connect -w cloud
> [  217.667382] wlan0: authenticate with 00:23:8e:e1:6c:c8 (try 1)
> [  217.864456] wlan0: authenticate with 00:23:8e:e1:6c:c8 (try 2)
> [  218.063975] wlan0: authenticate with 00:23:8e:e1:6c:c8 (try 3)
> [  218.263514] wlan0: authentication with 00:23:8e:e1:6c:c8 timed out

> # iw wlan0 connect -w cloud
> [  276.603232] wlan0: authenticate with 00:23:8e:e1:6c:c8 (try 1)
> [  276.802003] wlan0: authenticate with 00:23:8e:e1:6c:c8 (try 2)
> [  277.001461] wlan0: authenticate with 00:23:8e:e1:6c:c8 (try 3)
> [  277.200945] wlan0: authentication with 00:23:8e:e1:6c:c8 timed out

Using "debug=0xe01" with rmmod/modprobe causes no visible difference.
"pcie_aspm=off" did not help.

`lspci -v` shows the device as:

> 
> 03:00.0 Network controller: Atheros Communications Inc. AR9285 Wireless Network Adapter (PCI-Express) (rev 01)
>         Subsystem: AzureWave AW-NE785 / AW-NE785H 802.11bgn Wireless Full or Half-size Mini PCIe Card
>         Flags: bus master, fast devsel, latency 0, IRQ 17
>         Memory at d2a00000 (64-bit, non-prefetchable) [size=64K]
>         Capabilities: [40] Power Management version 3
>         Capabilities: [50] MSI: Enable- Count=1/1 Maskable- 64bit-
>         Capabilities: [60] Express Legacy Endpoint, MSI 00
>         Capabilities: [100] Advanced Error Reporting
>         Capabilities: [140] Virtual Channel
>         Capabilities: [160] Device Serial Number 00-15-17-ff-ff-24-14-12
>         Capabilities: [170] Power Budgeting <?>
>         Kernel driver in use: ath9k

-- 
Mantas M. <grawity@gmail.com


  parent reply	other threads:[~2012-04-04 10:40 UTC|newest]

Thread overview: 39+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2012-04-03  5:46 Kelly Anderson
2012-04-03  6:01 ` Ben Greear
2012-04-03  6:26   ` [ath9k-devel] " Mohammed Shafi
2012-04-03  6:49     ` Kelly Anderson
2012-04-03  7:16       ` Mohammed Shafi
2012-04-03  7:46         ` Kelly Anderson
2012-04-03  7:52           ` Mohammed Shafi
2012-04-03  8:04             ` Mohammed Shafi
2012-04-03  8:38               ` Kelly Anderson
2012-04-03 18:03                 ` Michael Leun
2012-04-04  7:29                   ` Mohammed Shafi
2012-04-04 15:03                     ` Mohammed Shafi
2012-04-04 21:51                       ` Michael Leun
2012-04-05  6:16                         ` Mohammed Shafi
2012-04-05 13:53                           ` Michael Leun
2012-04-05 18:25                         ` Ben Greear
2012-04-06  5:11                           ` Mohammed Shafi
2012-04-06 20:31                             ` Ben Greear
2012-04-08 23:08                               ` 3.4-rc ath9k regression (Re: [ath9k-devel] 3.3.1 ath9k regression) Michael Leun
2012-04-09  6:28                                 ` Mohammed Shafi
2012-04-09  8:45                                   ` Sergio Correia
2012-04-09 10:25                                   ` Michael Leun
2012-04-09 14:03                                     ` Michael Leun
2012-04-09 14:22                                       ` Mohammed Shafi
2012-04-09 15:29                                         ` Michael Leun
2012-04-10  5:48                                           ` Mohammed Shafi
2012-04-10 10:05                                             ` [ath9k-devel] 3.4-rc ath9k regression (Re: " Mohammed Shafi
2012-04-12 13:46                                           ` 3.4-rc ath9k regression (Re: [ath9k-devel] " Felix Fietkau
2012-04-12 13:58                                             ` Felipe Contreras
2012-04-12 15:35                                               ` Michael Leun
2012-04-12 18:11                                                 ` Felix Fietkau
2012-04-12 19:28                                                   ` Sergio Correia
2012-04-14 21:15                                                     ` Felipe Contreras
2012-04-12 22:01                                                   ` Michael Leun
2012-04-09 19:12                                 ` [ath9k-devel] 3.4-rc ath9k regression (Re: " Sujith Manoharan
2012-04-09 21:21                                   ` Michael Leun
2012-04-09  6:52                               ` [ath9k-devel] 3.3.1 ath9k regression Mohammed Shafi
2012-04-04 10:40 ` Mantas M. [this message]
     [not found] <iM4WB-6k6-3@gated-at.bofh.it>
     [not found] ` <iM56i-6N7-11@gated-at.bofh.it>
2012-04-04 19:33   ` Martin

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to='jlh8eg$gqs$1@dough.gmane.org' \
    --to=grawity@gmail.com \
    --cc=linux-kernel@vger.kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox

Powered by JetHome