Re: [PATCH] i386: always clear bss

[ebiederm@xmission.com (Eric W. Biederman)]

Jeremy Fitzhardinge <jeremy@goop.org> writes:

> When the paravirt dispatcher gets run immediately on entry to
> startup_32, the bss isn't cleared.  This happens to work if the
> hypervisor's domain builder loaded the complete kernel image and
> cleared the bss for us, but this may not always be true (for example,
> if we're running out of a decompressed bzImage).
>
> Change head.S so that it unconditionally clears the bss before doing
> the paravirt dispatch or continuing on to normal native boot.
>
> There are a couple of points to note:
>  - We can't, in general, load the segment registers before paravirt
>    dispatch, because we could be running with a non-standard gdt and
>    segment selectors.  In practice though, all code which ends up
>    jumping into startup_32 will have already set the segment registers
>    up to sane values, so we don't need to do it again.
>  - Paging may or may not be enabled, and if enabled we may or may not
>    be mapped to the proper kernel virtual address.  To deal with this,
>    we compare the kernel's linked address with where we're actually
>    running, and use that to offset the bss pointer.

NAK.  

Skipping the segment register load is likely fine.
Supporting V!=P at startup_32 is not.
Assuming that we have a stack at startup_32 is not.

If you want to figure out where the kernel is loaded you can do
(from arch/i386/boot/head.S)
> 
> /* Calculate the delta between where we were compiled to run
>  * at and where we were actually loaded at.  This can only be done
>  * with a short local call on x86.  Nothing  else will tell us what
>  * address we are running at.  The reserved chunk of the real-mode
>  * data at 0x34-0x3f are used as the stack for this calculation.
>  * Only 4 bytes are needed.
>  */
> 	leal 0x40(%esi), %esp
> 	call 1f
> 1:	popl %ebp
> 	subl $1b, %ebp
> 

Eric