* [PATCH AUTOSEL 4.19 04/64] arm: dts: meson: Fix IRQ trigger type for macirq
[not found] <20190228151105.11277-1-sashal@kernel.org>
@ 2019-02-28 15:10 ` Sasha Levin
2019-02-28 15:10 ` [PATCH AUTOSEL 4.19 05/64] ARM: dts: meson8b: odroidc1: mark the SD card detection GPIO active-low Sasha Levin
2019-02-28 15:10 ` [PATCH AUTOSEL 4.19 06/64] ARM: dts: meson8m2: mxiii-plus: " Sasha Levin
2 siblings, 0 replies; 3+ messages in thread
From: Sasha Levin @ 2019-02-28 15:10 UTC (permalink / raw)
To: linux-kernel, stable
Cc: Sasha Levin, Kevin Hilman, devicetree, linux-amlogic, Carlo Caione
From: Carlo Caione <ccaione@baylibre.com>
[ Upstream commit e35e26b26e955c53e61c154ba26b9bb15da6b858 ]
A long running stress test on a custom board shipping an AXG SoCs and a
Realtek RTL8211F PHY revealed that after a few hours the connection
speed would drop drastically, from ~1000Mbps to ~3Mbps. At the same time
the 'macirq' (eth0) IRQ would stop being triggered at all and as
consequence the GMAC IRQs never ACKed.
After a painful investigation the problem seemed to be due to a wrong
defined IRQ type for the GMAC IRQ that should be LEVEL_HIGH instead of
EDGE_RISING.
The change in the macirq IRQ type also solved another long standing
issue affecting this SoC/PHY where EEE was causing the network
connection to die after stressing it with iperf3 (even though much
sooner). It's now possible to remove the 'eee-broken-1000t' quirk as
well.
Fixes: 9c15795a4f96 ("ARM: dts: meson8b-odroidc1: ethernet support")
Signed-off-by: Carlo Caione <ccaione@baylibre.com>
Reviewed-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Tested-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Signed-off-by: Kevin Hilman <khilman@baylibre.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
arch/arm/boot/dts/meson.dtsi | 2 +-
arch/arm/boot/dts/meson8b-odroidc1.dts | 1 -
2 files changed, 1 insertion(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/meson.dtsi b/arch/arm/boot/dts/meson.dtsi
index 0d9faf1a51eac..a86b890863347 100644
--- a/arch/arm/boot/dts/meson.dtsi
+++ b/arch/arm/boot/dts/meson.dtsi
@@ -263,7 +263,7 @@
compatible = "amlogic,meson6-dwmac", "snps,dwmac";
reg = <0xc9410000 0x10000
0xc1108108 0x4>;
- interrupts = <GIC_SPI 8 IRQ_TYPE_EDGE_RISING>;
+ interrupts = <GIC_SPI 8 IRQ_TYPE_LEVEL_HIGH>;
interrupt-names = "macirq";
status = "disabled";
};
diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts
index ef3177d3da3dc..9e48936e2d8d7 100644
--- a/arch/arm/boot/dts/meson8b-odroidc1.dts
+++ b/arch/arm/boot/dts/meson8b-odroidc1.dts
@@ -125,7 +125,6 @@
/* Realtek RTL8211F (0x001cc916) */
eth_phy: ethernet-phy@0 {
reg = <0>;
- eee-broken-1000t;
interrupt-parent = <&gpio_intc>;
/* GPIOH_3 */
interrupts = <17 IRQ_TYPE_LEVEL_LOW>;
--
2.19.1
_______________________________________________
linux-amlogic mailing list
linux-amlogic@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-amlogic
^ permalink raw reply [flat|nested] 3+ messages in thread* [PATCH AUTOSEL 4.19 05/64] ARM: dts: meson8b: odroidc1: mark the SD card detection GPIO active-low
[not found] <20190228151105.11277-1-sashal@kernel.org>
2019-02-28 15:10 ` [PATCH AUTOSEL 4.19 04/64] arm: dts: meson: Fix IRQ trigger type for macirq Sasha Levin
@ 2019-02-28 15:10 ` Sasha Levin
2019-02-28 15:10 ` [PATCH AUTOSEL 4.19 06/64] ARM: dts: meson8m2: mxiii-plus: " Sasha Levin
2 siblings, 0 replies; 3+ messages in thread
From: Sasha Levin @ 2019-02-28 15:10 UTC (permalink / raw)
To: linux-kernel, stable
Cc: Martin Blumenstingl, Kevin Hilman, devicetree, linux-amlogic,
Sasha Levin
From: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
[ Upstream commit 3fb348e030319f20ebbde082a449d4bf8a96f2fd ]
After commit 89a5e15bcba87d ("gpio/mmc/of: Respect polarity in the device
tree") SD cards are not detected anymore.
The CD GPIO is "active low" on Odroid-C1. The MMC dt-bindings specify:
"[...] using the "cd-inverted" property means, that the CD line is active
high, i.e. it is high, when a card is inserted".
Fix the description of the SD card by marking it as GPIO_ACTIVE_LOW and
drop the "cd-inverted" property. This makes the definition consistent
with the existing dt-bindings and fixes the check whether an SD card is
inserted.
Fixes: e03efbce6bebf5 ("ARM: dts: meson8b-odroidc1: add microSD support")
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Tested-by: Anand Moon <linux.amoon@gmail.com>
Signed-off-by: Kevin Hilman <khilman@baylibre.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
arch/arm/boot/dts/meson8b-odroidc1.dts | 3 +--
1 file changed, 1 insertion(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts
index 9e48936e2d8d7..8fdeeffecbdbc 100644
--- a/arch/arm/boot/dts/meson8b-odroidc1.dts
+++ b/arch/arm/boot/dts/meson8b-odroidc1.dts
@@ -171,8 +171,7 @@
cap-sd-highspeed;
disable-wp;
- cd-gpios = <&gpio CARD_6 GPIO_ACTIVE_HIGH>;
- cd-inverted;
+ cd-gpios = <&gpio CARD_6 GPIO_ACTIVE_LOW>;
vmmc-supply = <&tflash_vdd>;
vqmmc-supply = <&tf_io>;
--
2.19.1
_______________________________________________
linux-amlogic mailing list
linux-amlogic@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-amlogic
^ permalink raw reply [flat|nested] 3+ messages in thread* [PATCH AUTOSEL 4.19 06/64] ARM: dts: meson8m2: mxiii-plus: mark the SD card detection GPIO active-low
[not found] <20190228151105.11277-1-sashal@kernel.org>
2019-02-28 15:10 ` [PATCH AUTOSEL 4.19 04/64] arm: dts: meson: Fix IRQ trigger type for macirq Sasha Levin
2019-02-28 15:10 ` [PATCH AUTOSEL 4.19 05/64] ARM: dts: meson8b: odroidc1: mark the SD card detection GPIO active-low Sasha Levin
@ 2019-02-28 15:10 ` Sasha Levin
2 siblings, 0 replies; 3+ messages in thread
From: Sasha Levin @ 2019-02-28 15:10 UTC (permalink / raw)
To: linux-kernel, stable
Cc: Martin Blumenstingl, Kevin Hilman, devicetree, linux-amlogic,
Sasha Levin
From: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
[ Upstream commit 8615f5596335db0978cea593dcd0070dc5f8b116 ]
After commit 89a5e15bcba87d ("gpio/mmc/of: Respect polarity in the device
tree") SD cards are not detected anymore.
The CD GPIO is "active low" on the MXIII-Plus. The MMC dt-bindings
specify: "[...] using the "cd-inverted" property means, that the CD line
is active high, i.e. it is high, when a card is inserted".
Fix the description of the SD card by marking it as GPIO_ACTIVE_LOW and
drop the "cd-inverted" property. This makes the definition consistent
with the existing dt-bindings and fixes the check whether an SD card is
inserted.
Fixes: 35ee52bea66c74 ("ARM: dts: meson8m2: add support for the Tronsmart MXIII Plus")
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Kevin Hilman <khilman@baylibre.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
arch/arm/boot/dts/meson8m2-mxiii-plus.dts | 3 +--
1 file changed, 1 insertion(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/meson8m2-mxiii-plus.dts b/arch/arm/boot/dts/meson8m2-mxiii-plus.dts
index f5853610b20b8..6ac02beb5fa72 100644
--- a/arch/arm/boot/dts/meson8m2-mxiii-plus.dts
+++ b/arch/arm/boot/dts/meson8m2-mxiii-plus.dts
@@ -206,8 +206,7 @@
cap-sd-highspeed;
disable-wp;
- cd-gpios = <&gpio CARD_6 GPIO_ACTIVE_HIGH>;
- cd-inverted;
+ cd-gpios = <&gpio CARD_6 GPIO_ACTIVE_LOW>;
vmmc-supply = <&vcc_3v3>;
};
--
2.19.1
_______________________________________________
linux-amlogic mailing list
linux-amlogic@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-amlogic
^ permalink raw reply [flat|nested] 3+ messages in thread