Missing natsemi PCI ID

Missing natsemi PCI ID

[Ro0tSiEgE LKML]

Taken from "lspci -vvv".
The computer is an HP Pavilion ze4145 notebook. Most of the devices do not
have corresponding PCI ID's in the kernel, but I am only worried about the
NIC right now.

00:12.0 Ethernet controller: National Semiconductor Corporation DP83815
(MacPhyter) Ethernet Controller
             Subsystem: Unknown device 3c08:2400
             Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
             Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium
>TAbort- <TAbort- <MAbort- >SERR- <PERR-
             Interrupt: pin A routed to IRQ 11
             Region 0: I/O ports at 8c00
             Region 1: Memory at e0003000 (32-bit, non-prefetchable)
             Capabilities: [40] Power Management version 2
                          Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=320mA
PME(D0+,D1+,D2+,D3hot+,D3cold+)
                          Status: D0 PME-Enable- DSel=0 DScale=0 PME-

Any help would be greatly appreciated, I've had this notebook for 6 months
and cannot use the network card under Linux. I tested it with Windows and
OpenBSD and the network card works fine under both.

--
Bubba Parker
lkml@ro0tsiege.org

Re: Missing natsemi PCI ID

[Tim Hockin]

On Tue, Aug 26, 2003 at 03:29:33PM -0500, Ro0tSiEgE LKML wrote:
> The computer is an HP Pavilion ze4145 notebook. Most of the devices do not
> have corresponding PCI ID's in the kernel, but I am only worried about the
> NIC right now.

What's wrong with the NIC?

> 00:12.0 Ethernet controller: National Semiconductor Corporation DP83815

if you load the natsemi driver, what do you get?

-- 
Notice that as computers are becoming easier and easier to use,
suddenly there's a big market for "Dummies" books.  Cause and effect,
or merely an ironic juxtaposition of unrelated facts?

Re: Missing natsemi PCI ID

[Roger Larsson]

On Tuesday 26 August 2003 22.29, Ro0tSiEgE LKML wrote:
> Taken from "lspci -vvv".
> The computer is an HP Pavilion ze4145 notebook. Most of the devices do not
> have corresponding PCI ID's in the kernel, but I am only worried about the
> NIC right now.
>
> 00:12.0 Ethernet controller: National Semiconductor Corporation DP83815
> (MacPhyter) Ethernet Controller
>              Subsystem: Unknown device 3c08:2400
>              Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
> ParErr- Stepping- SERR- FastB2B-
>              Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium
>
> >TAbort- <TAbort- <MAbort- >SERR- <PERR-
>
>              Interrupt: pin A routed to IRQ 11
>              Region 0: I/O ports at 8c00
>              Region 1: Memory at e0003000 (32-bit, non-prefetchable)
>              Capabilities: [40] Power Management version 2
>                           Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=320mA
> PME(D0+,D1+,D2+,D3hot+,D3cold+)
>                           Status: D0 PME-Enable- DSel=0 DScale=0 PME-
>
> Any help would be greatly appreciated, I've had this notebook for 6 months
> and cannot use the network card under Linux. I tested it with Windows and
> OpenBSD and the network card works fine under both.

Have you tried "# modprobe natsemi" ?
Followed by usual network configuration.

What distribution do you use?

/RogerL

-- 
Roger Larsson
Skellefteå
Sweden