Re: [PATCH 2/3] hwmon: spd5118: Retry temperature reads after temporary I2C errors

[Guenter Roeck <linux@roeck-us.net>]

On 1/10/26 09:19, Tinsae Tadesse wrote:
> After suspend/resume, the SPD5118 hub or the underlying I2C adapter
> may not be immediately available, causing register reads to fail.
> 
> Attempt a single regcache re-synchronization and retry the read to
> allow recovery.
> 
> Signed-off-by: Tinsae Tadesse <tinsaetadesse2015@gmail.com>
> ---
>   drivers/hwmon/spd5118.c | 11 ++++++++++-
>   1 file changed, 10 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/hwmon/spd5118.c b/drivers/hwmon/spd5118.c
> index ec9f14f6e0df..63f798991363 100644
> --- a/drivers/hwmon/spd5118.c
> +++ b/drivers/hwmon/spd5118.c
> @@ -101,6 +101,7 @@ static int spd5118_read_temp(struct regmap *regmap, u32 attr, long *val)
>   	int reg, err;
>   	u8 regval[2];
>   	u16 temp;
> +	bool retried = false;
>   
>   	switch (attr) {
>   	case hwmon_temp_input:
> @@ -122,9 +123,17 @@ static int spd5118_read_temp(struct regmap *regmap, u32 attr, long *val)
>   		return -EOPNOTSUPP;
>   	}
>   
> +retry:
>   	err = regmap_bulk_read(regmap, reg, regval, 2);
> -	if (err)
> +	if (err) {
> +		if (!retried && (err == -ENXIO || err == -EIO)) {
> +			retried = true;
> +			regcache_mark_dirty(regmap);
> +			if (!regcache_sync(regmap))
> +				goto retry;
> +		}
>   		return err;
> +	}
>   
>   	temp = (regval[1] << 8) | regval[0];
>   


Wrong solution. This affects all accesses, not just the first access after
resume. regmap_bulk_read() can fail for any reason, not just because the
system just returned from resume. The above code just assumes that the failure
is due to a bad resume based on the returned error code. That may be the case
for the i801 controller driver, but even that would be just by chance.

Guenter