Re: [PATCH v3 00/12] qrb4210-rb2: add wsa audio playback and capture support

[Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>]

On 22/05/2025 19:40, Alexey Klimov wrote:
> Rebased, updated, re-tested. This implements the playback support via the
> following path: RX1 from DSP is connected to rxmacro which communicates
> with wcd codec using soundwire. This goes into AUX input of wcd. Wcd codec
> outputs analog audio into wsa8815 amplifier. Capturing works through vamacro
> using one onboard DMIC which is directly connected to vamacro codec.
> 
> Changes since v2:
> -- dropped [PATCH v2 08/14] dt-bindings: arm: qcom-soc: extend pattern matching
> to support qcom,wsa881x and replaced with new one;
> -- dropped [PATCH v2 14/14] ASoC: qcom: sm8250: force single channel via RX_1 output for qrb4210
> -- reordered as suggested by Krzysztof;
> -- updates to wsa881x-common.h registers descriptions and corresponding updates
> to wsa881x-common.c (Konrad);
> -- sorted subnodes in DT alphabetically as suggested by Konrad;
> -- wsa881x bindings updates (as suggested by Krzysztof);

What exactly changed? This is way too vague.

> -- ASoC: dt-bindings: qcom: Add SM6115 LPASS rxmacro and vamacro codecs
> is still present;

What does it mean "still present"? You never responded to my comment. I
never asked to remove it, so I do not get why you mention it is still
present.

Best regards,
Krzysztof