Re: [PATCH v3 10/12] arm64: dts: qcom: qrb4210-rb2: enable wsa881x amplifier

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 5/22/25 7:41 PM, Alexey Klimov wrote:
> One WSA881X amplifier is connected on QRB4210 RB2 board
> hence only mono speaker is supported. This amplifier is set
> to work in analog mode only. Also add required powerdown
> pin/gpio.
> 
> Cc: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
> Signed-off-by: Alexey Klimov <alexey.klimov@linaro.org>
> ---
>  arch/arm64/boot/dts/qcom/qrb4210-rb2.dts | 26 ++++++++++++++++++++++++++
>  1 file changed, 26 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts b/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> index 6bce63720cfffd8e0e619937fb1f365cbbbcb283..4b878e585227ee6b3b362108be96aad99acba21d 100644
> --- a/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> +++ b/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> @@ -270,6 +270,24 @@ zap-shader {
>  	};
>  };
>  
> +&i2c1 {
> +	clock-frequency = <400000>;
> +	status = "okay";
> +
> +	wsa881x: amplifier@f {
> +		compatible = "qcom,wsa8815";
> +		reg = <0x0f>;
> +		pinctrl-0 = <&wsa_en_active>;
> +		pinctrl-names = "default";
> +		clocks = <&q6afecc LPASS_CLK_ID_MCLK_2 LPASS_CLK_ATTRIBUTE_COUPLE_NO>;
> +		powerdown-gpios = <&lpass_tlmm 16 GPIO_ACTIVE_LOW>;
> +		mclk-gpios = <&lpass_tlmm 18 GPIO_ACTIVE_HIGH>;
> +		sound-name-prefix = "SpkrMono";
> +		#sound-dai-cells = <0>;
> +		#thermal-sensor-cells = <0>;
> +	};
> +};
> +
>  &i2c2_gpio {
>  	clock-frequency = <400000>;
>  	status = "okay";
> @@ -736,6 +754,14 @@ wcd_reset_n: wcd-reset-n-state {
>  		drive-strength = <16>;
>  		output-high;
>  	};
> +
> +	wsa_en_active: wsa-en-active-state {
> +		pins = "gpio106";

Are there two separate enable pins? Or is the powerdown-gpio something
else?

Konrad