[PATCH 3/5] kmemtrace: fix kernel parameter documentation

[Frederic Weisbecker <fweisbec@gmail.com>]

From: Pekka Enberg <penberg@cs.helsinki.fi>

The kmemtrace.enable kernel parameter no longer works. To enable
kmemtrace at boot-time, you must pass "ftrace=kmemtrace" instead.

[ Impact: remove obsolete kernel parameter documentation ]

Cc: Eduard - Gabriel Munteanu <eduard.munteanu@linux360.ro>
Signed-off-by: Pekka Enberg <penberg@cs.helsinki.fi>
LKML-Reference: <alpine.DEB.2.00.0905241112190.10296@rocky>
Signed-off-by: Frederic Weisbecker <fweisbec@gmail.com>
---
 Documentation/kernel-parameters.txt |   10 ----------
 1 files changed, 0 insertions(+), 10 deletions(-)

diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index e87bdbf..9243dd8 100644
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -56,7 +56,6 @@ parameter is applicable:
 	ISAPNP	ISA PnP code is enabled.
 	ISDN	Appropriate ISDN support is enabled.
 	JOY	Appropriate joystick support is enabled.
-	KMEMTRACE kmemtrace is enabled.
 	LIBATA  Libata driver is enabled
 	LP	Printer support is enabled.
 	LOOP	Loopback device support is enabled.
@@ -1054,15 +1053,6 @@ and is between 256 and 4096 characters. It is defined in the file
 			use the HighMem zone if it exists, and the Normal
 			zone if it does not.
 
-	kmemtrace.enable=	[KNL,KMEMTRACE] Format: { yes | no }
-				Controls whether kmemtrace is enabled
-				at boot-time.
-
-	kmemtrace.subbufs=n	[KNL,KMEMTRACE] Overrides the number of
-			subbufs kmemtrace's relay channel has. Set this
-			higher than default (KMEMTRACE_N_SUBBUFS in code) if
-			you experience buffer overruns.
-
 	kgdboc=		[HW] kgdb over consoles.
 			Requires a tty driver that supports console polling.
 			(only serial suported for now)
-- 
1.6.2.3