Re: [PATCH] add SBC-FITPC2 watchdog driver

[Joe Perches <joe@perches.com>]

On Mon, 2009-07-20 at 18:53 +0300, Mike Rapoport wrote:
> diff -Nru linux-2.6.31-rc3.orig/drivers/watchdog/sbc_fitpc2_wdt.c linux-2.6.31-rc3/drivers/watchdog/sbc_fitpc2_wdt.c
> --- linux-2.6.31-rc3.orig/drivers/watchdog/sbc_fitpc2_wdt.c	1970-01-01 02:00:00.000000000 +0200
> +++ linux-2.6.31-rc3/drivers/watchdog/sbc_fitpc2_wdt.c	2009-07-20 16:08:40.000000000 +0300

Hi.  Some trivial comments below:

[]

> +static ssize_t
> +fitpc2_wdt_write(struct file *file, const char *data, size_t len, loff_t *ppos)
> +{
> +	if (len) {
> +		if (!nowayout) {
> +			size_t i;

using
	if (!len)
		return 0;
	if (nowayout) {
		wdt_enable();
		return 0;
	}

would reduce the indent a couple of levels.

[]

> +static int fitpc2_wdt_release(struct inode *inode, struct file *file)
> +{
> +	if (test_bit(WDT_OK_TO_CLOSE, &wdt_status)) {
> +		wdt_disable();
> +		printk(KERN_CRIT "WATCHDOG: Device disabled\n");

I think you should verify the printk KERN_CRIT uses.
This seems like this one should be KERN_INFO.

[]

> +static int __init fitpc2_wdt_init(void)
[]
> +		printk(KERN_CRIT "WATCHDOG: board name is: %s. Should be SBC-FITPC2\n",
> +			dmi_get_system_info(DMI_BOARD_NAME));
[]
> +		printk(KERN_CRIT "WATCHDOG: I/O address 0x%04x already in use\n",
> +			COMMAND_PORT);
[]
> +		printk(KERN_CRIT "WATCHDOG: I/O address 0x%04x already in use\n",
> +			DATA_PORT);
[]
> +		printk(KERN_CRIT "WATCHDOG: margin must be in range 31 - 255"
> +		" seconds, you tried to set %d\n", margin);

Maybe all of these should be KERN_ERR.

You could use:

#define pr_fmt(fmt) KBUILD_MODNAME " WATCHDOG: " fmt

and convert the printk(KERN_<level> "WATCHDOG: " etc...)
to pr_<level>(etc...)