[PATCH v5] gpio: Device tree support for LPC32xx

[PATCH v5] gpio: Device tree support for LPC32xx

[Roland Stigge]

This patch adds device tree support for gpio-lpc32xx.c

Signed-off-by: Roland Stigge <stigge@antcom.de>

---

 Applies to v3.4-rc3

 Changes since last version:
 * Typo fix in documentation
 * Changed "compatible" strings to non-wildcard versions
 * Removed Arnd Bergmann's "Reviewed-by:" due to above change
 
 Documentation/devicetree/bindings/gpio/gpio_lpc32xx.txt |   66 ++++++++++++++++
 arch/arm/mach-lpc32xx/include/mach/gpio.h               |    9 +-
 drivers/gpio/gpio-lpc32xx.c                             |   55 ++++++++++++-
 3 files changed, 127 insertions(+), 3 deletions(-)

--- /dev/null
+++ linux-2.6/Documentation/devicetree/bindings/gpio/gpio_lpc32xx.txt
@@ -0,0 +1,66 @@
+NXP LPC32xx SoC GPIO controller
+
+Required properties:
+- compatible: must be "nxp,lpc3220-gpio", "nxp,lpc3230-gpio", "nxp,lpc3240-gpio"
+  or "nxp,lpc3250-gpio"
+- reg: Physical base address and length of the controller's registers.
+- #address-cells: Always 1, for indexing of the subnodes (GPIO groups of the
+  SoC)
+- #size-cells: Always 0
+
+Required properties of sub-nodes which describe the GPIO groups of LPC32xx:
+- gpio-controller: Marks the device node as a GPIO controller.
+- #gpio-cells: Should be two. The first cell is the pin number and the
+  second cell is used to specify optional parameters:
+  - bit 0 specifies polarity (0 for normal, 1 for inverted)
+- reg: Index of the GPIO group
+
+Optional properties of sub-nodes which describe the GPIO groups of LPC32xx:
+- status: Set to "disabled" if you don't use the respective GPIO group
+  of the LPC32xx SoC
+
+Example:
+
+	gpio: gpio@40028000 {
+		compatible = "nxp,lpc3250-gpio";
+		reg = <0x40028000 0x1000>;
+		/* create a private address space for enumeration */
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		gpio_p0: gpio-bank@0 {
+			gpio-controller;
+			#gpio-cells = <2>;
+			reg = <0>;
+		};
+
+		gpio_p1: gpio-bank@1 {
+			gpio-controller;
+			#gpio-cells = <2>;
+			reg = <1>;
+		};
+
+		gpio_p2: gpio-bank@2 {
+			gpio-controller;
+			#gpio-cells = <2>;
+			reg = <2>;
+		};
+
+		gpio_p3: gpio-bank@3 {
+			gpio-controller;
+			#gpio-cells = <2>;
+			reg = <3>;
+		};
+
+		gpi_p3: gpio-bank@4 {
+			gpio-controller;
+			#gpio-cells = <2>;
+			reg = <4>;
+		};
+
+		gpo_p3: gpio-bank@5 {
+			gpio-controller;
+			#gpio-cells = <2>;
+			reg = <5>;
+		};
+	};
--- linux-2.6.orig/arch/arm/mach-lpc32xx/include/mach/gpio.h
+++ linux-2.6/arch/arm/mach-lpc32xx/include/mach/gpio.h
@@ -1 +1,8 @@
-/* empty */
+#ifndef __MACH_GPIO_H
+#define __MACH_GPIO_H
+
+#include "gpio-lpc32xx.h"
+
+#define ARCH_NR_GPIOS (LPC32XX_GPO_P3_GRP + LPC32XX_GPO_P3_MAX)
+
+#endif /* __MACH_GPIO_H */
--- linux-2.6.orig/drivers/gpio/gpio-lpc32xx.c
+++ linux-2.6/drivers/gpio/gpio-lpc32xx.c
@@ -21,6 +21,9 @@
 #include <linux/io.h>
 #include <linux/errno.h>
 #include <linux/gpio.h>
+#include <linux/of_gpio.h>
+#include <linux/platform_device.h>
+#include <linux/module.h>
 
 #include <mach/hardware.h>
 #include <mach/platform.h>
@@ -454,10 +457,58 @@ static struct lpc32xx_gpio_chip lpc32xx_
 	},
 };
 
+/* Empty now, can be removed later when mach-lpc32xx is finally switched over
+ * to DT support
+ */
 void __init lpc32xx_gpio_init(void)
 {
+}
+
+static int __devinit lpc32xx_gpio_probe(struct platform_device *pdev)
+{
+	struct device_node *node;
 	int i;
 
-	for (i = 0; i < ARRAY_SIZE(lpc32xx_gpiochip); i++)
-		gpiochip_add(&lpc32xx_gpiochip[i].chip);
+	if (pdev->dev.of_node) {
+		for_each_child_of_node(pdev->dev.of_node, node) {
+			if (of_device_is_available(node)) {
+				u32 index;
+				struct gpio_chip *chip;
+				if (of_property_read_u32(node,
+							 "reg", &index) <  0)
+					continue;
+				if (index >= ARRAY_SIZE(lpc32xx_gpiochip))
+					continue;
+				chip = &lpc32xx_gpiochip[index].chip;
+				chip->of_node = of_node_get(node);
+				gpiochip_add(chip);
+			}
+		}
+	} else {
+		for (i = 0; i < ARRAY_SIZE(lpc32xx_gpiochip); i++)
+			gpiochip_add(&lpc32xx_gpiochip[i].chip);
+	}
+
+	return 0;
 }
+
+#ifdef CONFIG_OF
+static struct of_device_id lpc32xx_gpio_of_match[] __devinitdata = {
+	{ .compatible = "nxp,lpc3220-gpio", },
+	{ .compatible = "nxp,lpc3230-gpio", },
+	{ .compatible = "nxp,lpc3240-gpio", },
+	{ .compatible = "nxp,lpc3250-gpio", },
+	{ },
+};
+#endif
+
+static struct platform_driver lpc32xx_gpio_driver = {
+	.driver		= {
+		.name	= "lpc32xx-gpio",
+		.owner	= THIS_MODULE,
+		.of_match_table = of_match_ptr(lpc32xx_gpio_of_match),
+	},
+	.probe		= lpc32xx_gpio_probe,
+};
+
+module_platform_driver(lpc32xx_gpio_driver);

Re: [PATCH v5] gpio: Device tree support for LPC32xx

[Jean-Christophe PLAGNIOL-VILLARD]

On 09:55 Sat 21 Apr     , Roland Stigge wrote:
> This patch adds device tree support for gpio-lpc32xx.c
> 
> Signed-off-by: Roland Stigge <stigge@antcom.de>
> 
> ---
> 
>  Applies to v3.4-rc3
> 
>  Changes since last version:
>  * Typo fix in documentation
>  * Changed "compatible" strings to non-wildcard versions
>  * Removed Arnd Bergmann's "Reviewed-by:" due to above change
>  
>  Documentation/devicetree/bindings/gpio/gpio_lpc32xx.txt |   66 ++++++++++++++++
>  arch/arm/mach-lpc32xx/include/mach/gpio.h               |    9 +-
>  drivers/gpio/gpio-lpc32xx.c                             |   55 ++++++++++++-
>  3 files changed, 127 insertions(+), 3 deletions(-)
> 
> --- /dev/null
> +++ linux-2.6/Documentation/devicetree/bindings/gpio/gpio_lpc32xx.txt
> @@ -0,0 +1,66 @@
> +NXP LPC32xx SoC GPIO controller
> +
> +Required properties:
> +- compatible: must be "nxp,lpc3220-gpio", "nxp,lpc3230-gpio", "nxp,lpc3240-gpio"
> +  or "nxp,lpc3250-gpio"
same comment as on the ADC you don't need to list all

just put the first soc where this IP was used
> +- reg: Physical base address and length of the controller's registers.
> +- #address-cells: Always 1, for indexing of the subnodes (GPIO groups of the
> +  SoC)
> +- #size-cells: Always 0
> +
> +Required properties of sub-nodes which describe the GPIO groups of LPC32xx:
> +- gpio-controller: Marks the device node as a GPIO controller.
> +- #gpio-cells: Should be two. The first cell is the pin number and the
> +  second cell is used to specify optional parameters:
> +  - bit 0 specifies polarity (0 for normal, 1 for inverted)
> +- reg: Index of the GPIO group
> +
> +Optional properties of sub-nodes which describe the GPIO groups of LPC32xx:
> +- status: Set to "disabled" if you don't use the respective GPIO group
> +  of the LPC32xx SoC
> +
> +Example:
> +
> +	gpio: gpio@40028000 {
> +		compatible = "nxp,lpc3250-gpio";
> +		reg = <0x40028000 0x1000>;
> +		/* create a private address space for enumeration */
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +
> +		gpio_p0: gpio-bank@0 {
> +			gpio-controller;
> +			#gpio-cells = <2>;
> +			reg = <0>;
> +		};
> +
> +		gpio_p1: gpio-bank@1 {
> +			gpio-controller;
> +			#gpio-cells = <2>;
> +			reg = <1>;
> +		};
> +
> +		gpio_p2: gpio-bank@2 {
> +			gpio-controller;
> +			#gpio-cells = <2>;
> +			reg = <2>;
> +		};
> +
> +		gpio_p3: gpio-bank@3 {
> +			gpio-controller;
> +			#gpio-cells = <2>;
> +			reg = <3>;
> +		};
> +
> +		gpi_p3: gpio-bank@4 {
> +			gpio-controller;
> +			#gpio-cells = <2>;
> +			reg = <4>;
> +		};
> +
> +		gpo_p3: gpio-bank@5 {
> +			gpio-controller;
> +			#gpio-cells = <2>;
> +			reg = <5>;
> +		};
> +	};
> --- linux-2.6.orig/arch/arm/mach-lpc32xx/include/mach/gpio.h
> +++ linux-2.6/arch/arm/mach-lpc32xx/include/mach/gpio.h
> @@ -1 +1,8 @@
> -/* empty */
> +#ifndef __MACH_GPIO_H
> +#define __MACH_GPIO_H
> +
> +#include "gpio-lpc32xx.h"
> +
> +#define ARCH_NR_GPIOS (LPC32XX_GPO_P3_GRP + LPC32XX_GPO_P3_MAX)
> +
> +#endif /* __MACH_GPIO_H */
> --- linux-2.6.orig/drivers/gpio/gpio-lpc32xx.c
> +++ linux-2.6/drivers/gpio/gpio-lpc32xx.c
> @@ -21,6 +21,9 @@
>  #include <linux/io.h>
>  #include <linux/errno.h>
>  #include <linux/gpio.h>
> +#include <linux/of_gpio.h>
> +#include <linux/platform_device.h>
> +#include <linux/module.h>
>  
>  #include <mach/hardware.h>
>  #include <mach/platform.h>
> @@ -454,10 +457,58 @@ static struct lpc32xx_gpio_chip lpc32xx_
>  	},
>  };
>  
> +/* Empty now, can be removed later when mach-lpc32xx is finally switched over
> + * to DT support
> + */
>  void __init lpc32xx_gpio_init(void)
>  {
> +}
> +
> +static int __devinit lpc32xx_gpio_probe(struct platform_device *pdev)
> +{
> +	struct device_node *node;
>  	int i;
>  
> -	for (i = 0; i < ARRAY_SIZE(lpc32xx_gpiochip); i++)
> -		gpiochip_add(&lpc32xx_gpiochip[i].chip);
> +	if (pdev->dev.of_node) {
> +		for_each_child_of_node(pdev->dev.of_node, node) {
> +			if (of_device_is_available(node)) {
> +				u32 index;
> +				struct gpio_chip *chip;
> +				if (of_property_read_u32(node,
> +							 "reg", &index) <  0)
> +					continue;
> +				if (index >= ARRAY_SIZE(lpc32xx_gpiochip))
> +					continue;
> +				chip = &lpc32xx_gpiochip[index].chip;
> +				chip->of_node = of_node_get(node);
> +				gpiochip_add(chip);
split this in an toher function so it's more readble

Best Regards,
J.