[PATCH] mfd: wm8994: Remove check for active audio in runtime suspend

[PATCH] mfd: wm8994: Remove check for active audio in runtime suspend

[Mark Brown]

From: Mark Brown <broonie@linaro.org>

Since enabling VMID takes a runtime PM reference there is no need to
suppress suspend when doing a runtime suspend. Similarly the digital
inputs and outputs are DAPM widgets and therefore the ASoC core will
be holding a reference for them.

This used to be required when integration with system suspend was being
bodged.

Signed-off-by: Mark Brown <broonie@linaro.org>
---
 drivers/mfd/wm8994-core.c | 30 +-----------------------------
 1 file changed, 1 insertion(+), 29 deletions(-)

diff --git a/drivers/mfd/wm8994-core.c b/drivers/mfd/wm8994-core.c
index e8ecb8e..e1c283e 100644
--- a/drivers/mfd/wm8994-core.c
+++ b/drivers/mfd/wm8994-core.c
@@ -201,35 +201,7 @@ static int wm8994_suspend(struct device *dev)
 	int ret;
 
 	/* Don't actually go through with the suspend if the CODEC is
-	 * still active (eg, for audio passthrough from CP. */
-	ret = wm8994_reg_read(wm8994, WM8994_POWER_MANAGEMENT_1);
-	if (ret < 0) {
-		dev_err(dev, "Failed to read power status: %d\n", ret);
-	} else if (ret & WM8994_VMID_SEL_MASK) {
-		dev_dbg(dev, "CODEC still active, ignoring suspend\n");
-		return 0;
-	}
-
-	ret = wm8994_reg_read(wm8994, WM8994_POWER_MANAGEMENT_4);
-	if (ret < 0) {
-		dev_err(dev, "Failed to read power status: %d\n", ret);
-	} else if (ret & (WM8994_AIF2ADCL_ENA | WM8994_AIF2ADCR_ENA |
-			  WM8994_AIF1ADC2L_ENA | WM8994_AIF1ADC2R_ENA |
-			  WM8994_AIF1ADC1L_ENA | WM8994_AIF1ADC1R_ENA)) {
-		dev_dbg(dev, "CODEC still active, ignoring suspend\n");
-		return 0;
-	}
-
-	ret = wm8994_reg_read(wm8994, WM8994_POWER_MANAGEMENT_5);
-	if (ret < 0) {
-		dev_err(dev, "Failed to read power status: %d\n", ret);
-	} else if (ret & (WM8994_AIF2DACL_ENA | WM8994_AIF2DACR_ENA |
-			  WM8994_AIF1DAC2L_ENA | WM8994_AIF1DAC2R_ENA |
-			  WM8994_AIF1DAC1L_ENA | WM8994_AIF1DAC1R_ENA)) {
-		dev_dbg(dev, "CODEC still active, ignoring suspend\n");
-		return 0;
-	}
-
+	 * still active for accessory detect. */
 	switch (wm8994->type) {
 	case WM8958:
 	case WM1811:
-- 
1.8.3.1