[PATCH v5 04/12] drm: bridge: analogix: Destroy connector & encoder when unbinding

[Jeffy Chen <jeffy.chen@rock-chips.com>]

Normally we do this in drm_mode_config_cleanup. But:
1/ analogix dp's connector is allocated in bind, and freed after unbind.
So we need to destroy it in unbind to avoid further access.
2/ the drm bridge is attached in bind, and detached in encoder cleanup.
So we need to destroy encoder in unbind.

Signed-off-by: Jeffy Chen <jeffy.chen@rock-chips.com>
---

Changes in v5: None
Changes in v4:
Address Andrzej Hajda <a.hajda@samsung.com>'s comments.

Changes in v3: None
Changes in v2: None

 drivers/gpu/drm/bridge/analogix/analogix_dp_core.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
index d05ade4..4c758ed 100644
--- a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
+++ b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
@@ -1439,6 +1439,8 @@ void analogix_dp_unbind(struct device *dev, struct device *master,
 	struct analogix_dp_device *dp = dev_get_drvdata(dev);
 
 	analogix_dp_bridge_disable(dp->bridge);
+	dp->connector.funcs->destroy(&dp->connector);
+	dp->encoder->funcs->destroy(dp->encoder);
 
 	if (dp->plat_data->panel) {
 		if (drm_panel_unprepare(dp->plat_data->panel))
-- 
2.1.4