[PATCH 5/5] scsi: libsas: Resume SAS host for phy reset or enable via sysfs

[John Garry <john.garry@huawei.com>]

From: Xiang Chen <chenxiang66@hisilicon.com>

Currently if a phy reset or enable phy is issued via sysfs when controller
is suspended, those operations will be ignored as SAS_HA_REGISTERED is
cleared. If RPM is enabled then we may aggressively suspend automatically.
In this case it may be difficult to enable or reset a phy via sysfs, so
resume the host in these scenarios.

Signed-off-by: Xiang Chen <chenxiang66@hisilicon.com>
Signed-off-by: John Garry <john.garry@huawei.com>
---
 drivers/scsi/libsas/sas_init.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/scsi/libsas/sas_init.c b/drivers/scsi/libsas/sas_init.c
index dc35f0f8eae3..e4f77072a58d 100644
--- a/drivers/scsi/libsas/sas_init.c
+++ b/drivers/scsi/libsas/sas_init.c
@@ -531,6 +531,7 @@ static int queue_phy_reset(struct sas_phy *phy, int hard_reset)
 	if (!d)
 		return -ENOMEM;
 
+	pm_runtime_get_sync(ha->dev);
 	/* libsas workqueue coordinates ata-eh reset with discovery */
 	mutex_lock(&d->event_lock);
 	d->reset_result = 0;
@@ -544,6 +545,7 @@ static int queue_phy_reset(struct sas_phy *phy, int hard_reset)
 	if (rc == 0)
 		rc = d->reset_result;
 	mutex_unlock(&d->event_lock);
+	pm_runtime_put_sync(ha->dev);
 
 	return rc;
 }
@@ -558,6 +560,7 @@ static int queue_phy_enable(struct sas_phy *phy, int enable)
 	if (!d)
 		return -ENOMEM;
 
+	pm_runtime_get_sync(ha->dev);
 	/* libsas workqueue coordinates ata-eh reset with discovery */
 	mutex_lock(&d->event_lock);
 	d->enable_result = 0;
@@ -571,6 +574,7 @@ static int queue_phy_enable(struct sas_phy *phy, int enable)
 	if (rc == 0)
 		rc = d->enable_result;
 	mutex_unlock(&d->event_lock);
+	pm_runtime_put_sync(ha->dev);
 
 	return rc;
 }
-- 
2.35.3