From: "Rafael J. Wysocki" <rjw@rjwysocki.net>
To: Steve Muckle <steve.muckle@linaro.org>
Cc: Linux PM list <linux-pm@vger.kernel.org>,
Peter Zijlstra <peterz@infradead.org>,
Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com>,
Viresh Kumar <viresh.kumar@linaro.org>,
Linux Kernel Mailing List <linux-kernel@vger.kernel.org>,
Juri Lelli <juri.lelli@arm.com>, Ingo Molnar <mingo@kernel.org>
Subject: Re: [RFC][PATCH 6/7] cpufreq: schedutil: Add iowait boosting
Date: Wed, 03 Aug 2016 01:03:23 +0200 [thread overview]
Message-ID: <1808398.B5hOCmgoWi@vostro.rjw.lan> (raw)
In-Reply-To: <20160802013531.GC9332@graphite.smuckle.net>
On Monday, August 01, 2016 06:35:31 PM Steve Muckle wrote:
> On Mon, Aug 01, 2016 at 01:37:59AM +0200, Rafael J. Wysocki wrote:
> > From: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
> >
> > Modify the schedutil cpufreq governor to boost the CPU frequency
> > if the UUF_IO flag is passed to it via cpufreq_update_util().
> >
> > If that happens, the frequency is set to the maximum during
> > the first update after receiving the UUF_IO flag and then the
> > boost is reduced by half during each following update.
>
> Were these changes to schedutil part of the positive test results
> mentioned in patch 5? Or are those just from intel pstate?
>
> I was nervous about the effect of this on power and tested a couple low
> power usecases. The platform is the Hikey 96board (8 core ARM A53,
> single CPUfreq domain) running AOSP Android and schedutil backported to
> kernel 4.4. These tests run mp3 and mpeg4 playback for a little while,
> recording total energy consumption during the test along with frequency
> residency.
>
> As the results below show I did not measure an appreciable effect - if
> anything things may be slightly better with the patches.
>
> The hardcoding of a non-tunable boosting scheme makes me nervous but
> perhaps it could be revisited if some platform or configuration shows
> a noticeable regression?
That would be my approach. :-)
I'm not a big fan of tunables in general, as there are only a few people
who actually set them to anything different from the default and then they
get a lot of focus (even though they are after super-corner cases sometimes).
Thanks,
Rafael
next prev parent reply other threads:[~2016-08-02 22:58 UTC|newest]
Thread overview: 51+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-07-31 23:31 [RFC][PATCH 0/7] cpufreq / sched: cpufreq_update_util() flags and " Rafael J. Wysocki
2016-07-31 23:34 ` [RFC][PATCH 1/7] cpufreq / sched: Make schedutil access utilization data directly Rafael J. Wysocki
2016-08-01 19:28 ` Steve Muckle
2016-08-01 23:46 ` Rafael J. Wysocki
2016-08-02 10:38 ` Juri Lelli
2016-08-02 14:28 ` Steve Muckle
2016-08-02 14:43 ` Juri Lelli
2016-08-08 10:38 ` Peter Zijlstra
2016-07-31 23:35 ` [RFC][PATCH 2/7] cpufreq / sched: Drop cpufreq_trigger_update() Rafael J. Wysocki
2016-07-31 23:36 ` [RFC][PATCH 3/7] cpufreq / sched: Check cpu_of(rq) in cpufreq_update_util() Rafael J. Wysocki
2016-08-01 7:29 ` Dominik Brodowski
2016-08-01 14:57 ` Rafael J. Wysocki
2016-08-01 19:48 ` Steve Muckle
2016-08-01 23:43 ` Rafael J. Wysocki
2016-07-31 23:36 ` [RFC][PATCH 4/7] cpufreq / sched: Add flags argument to cpufreq_update_util() Rafael J. Wysocki
2016-08-01 7:33 ` Dominik Brodowski
2016-08-01 14:57 ` Rafael J. Wysocki
2016-08-01 19:59 ` Steve Muckle
2016-08-01 23:44 ` Rafael J. Wysocki
2016-08-02 1:36 ` Steve Muckle
2016-07-31 23:37 ` [RFC][PATCH 5/7] cpufreq / sched: UUF_IO flag to indicate iowait condition Rafael J. Wysocki
2016-08-02 1:22 ` Steve Muckle
2016-08-02 1:37 ` Rafael J. Wysocki
2016-08-02 22:02 ` Steve Muckle
2016-08-02 22:38 ` Rafael J. Wysocki
2016-08-04 2:24 ` Steve Muckle
2016-08-04 21:19 ` Rafael J. Wysocki
2016-08-04 22:09 ` Steve Muckle
2016-08-05 23:36 ` Rafael J. Wysocki
2016-07-31 23:37 ` [RFC][PATCH 6/7] cpufreq: schedutil: Add iowait boosting Rafael J. Wysocki
2016-08-02 1:35 ` Steve Muckle
2016-08-02 23:03 ` Rafael J. Wysocki [this message]
2016-07-31 23:38 ` [RFC][PATCH 7/7] cpufreq: intel_pstate: Change P-state selection algorithm for Core Rafael J. Wysocki
2016-08-04 4:18 ` Doug Smythies
2016-08-04 6:53 ` Doug Smythies
2016-08-06 0:02 ` Rafael J. Wysocki
2016-08-09 17:16 ` Doug Smythies
2016-08-13 15:59 ` Doug Smythies
2016-08-19 14:47 ` Peter Zijlstra
2016-08-20 1:06 ` Rafael J. Wysocki
2016-08-20 6:40 ` Doug Smythies
2016-08-22 18:53 ` Srinivas Pandruvada
2016-08-22 22:53 ` Doug Smythies
2016-08-23 3:48 ` Wanpeng Li
2016-08-23 4:08 ` Srinivas Pandruvada
2016-08-23 4:50 ` Wanpeng Li
2016-08-23 17:30 ` Rafael J. Wysocki
2016-08-01 15:26 ` [RFC][PATCH 0/7] cpufreq / sched: cpufreq_update_util() flags and iowait boosting Doug Smythies
2016-08-01 16:30 ` Rafael J. Wysocki
2016-08-08 11:08 ` Peter Zijlstra
2016-08-08 13:01 ` Rafael J. Wysocki
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1808398.B5hOCmgoWi@vostro.rjw.lan \
--to=rjw@rjwysocki.net \
--cc=juri.lelli@arm.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-pm@vger.kernel.org \
--cc=mingo@kernel.org \
--cc=peterz@infradead.org \
--cc=srinivas.pandruvada@linux.intel.com \
--cc=steve.muckle@linaro.org \
--cc=viresh.kumar@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®