Re: bonding quits working properly after a short time

["willy tarreau" <wtarreau@yahoo.fr>]

> I have disabled the bonding for now.  This system 
> has been working fine without bonding for quite 
> some time with 2.4.14pre6 using eth0. 
 
since you've disabled bonding, have you tried 
both interfaces or only one of them ? eg: if 
your system works fine on the tulip, it may be 
the other one behaving badly. 
  
> also, in searching about this problem I read some 
> old messages about bonding being non SMP safe, 
> is that still true? this is a dual PPro 200 
> system. 
 
very old, it was one of the reasons I modified 
the driver a few years ago, and should be OK 
now. 
  
> P.S.  I didn't see anything in the MAINTAINERS 
> file on bonding but Willy's name seems to be 
> associated with the project so I cc'd him. 
 
well, I don't have much time to spend on this 
anymore, perhaps Chad Tindel has, but I doubt it. 
that's the reason why I nearly didn't work on 
the 2.4 port. But I still read reports, and 
sometimes reply :-) 
 
Cheers, 
Willy 


___________________________________________________________
Do You Yahoo!? -- Une adresse @yahoo.fr gratuite et en français !
Yahoo! Mail : http://fr.mail.yahoo.com