* Re: bonding quits working properly after a short time
[not found] <69DCAE8DF2BFD411AACC0002A50A63F016BC7BAD@cdptex1.adelphiacom.com>
@ 2002-08-30 14:15 ` willy tarreau
0 siblings, 0 replies; only message in thread
From: willy tarreau @ 2002-08-30 14:15 UTC (permalink / raw)
To: Sam James, linux-kernel; +Cc: willy
> I have disabled the bonding for now. This system
> has been working fine without bonding for quite
> some time with 2.4.14pre6 using eth0.
since you've disabled bonding, have you tried
both interfaces or only one of them ? eg: if
your system works fine on the tulip, it may be
the other one behaving badly.
> also, in searching about this problem I read some
> old messages about bonding being non SMP safe,
> is that still true? this is a dual PPro 200
> system.
very old, it was one of the reasons I modified
the driver a few years ago, and should be OK
now.
> P.S. I didn't see anything in the MAINTAINERS
> file on bonding but Willy's name seems to be
> associated with the project so I cc'd him.
well, I don't have much time to spend on this
anymore, perhaps Chad Tindel has, but I doubt it.
that's the reason why I nearly didn't work on
the 2.4 port. But I still read reports, and
sometimes reply :-)
Cheers,
Willy
___________________________________________________________
Do You Yahoo!? -- Une adresse @yahoo.fr gratuite et en français !
Yahoo! Mail : http://fr.mail.yahoo.com
^ permalink raw reply [flat|nested] only message in thread