SGA155D DMA Burst length question - Memory to S5933

SGA155D DMA Burst length question - Memory to S5933

[Horvath Gyorgy]

Hi all,

I am on the way developing the driver for SGA155D.
The core driver is OK. I simply copy the firmware.bin file
to /dev/sga155d0, and after the firmware identification -
a proper satellite driver is loaded - actually the POS
(Packet Over SONET).
I can then ifconfig my pos0 - and here weeee goooo.

Now I can DMA well from the card to the PC memory -
even for long-bursts. The data is OK.
I see on the oscilloscope a short transfer at the beginning
(8 DWORDS or so) - a little gap, and the rest go smoothly
in one long piece.

I tried then to DMA from the PC memory to the card.
What I see is: 9 DWORDS, some 9+more gap, 9 DWORDS, some 9 more gap,
etc...
I'd like to see a smooooooooooth transfer - not that 50%.

I have S5933 on-board, and I find some issues elsewhere
about advanced PCI commands when spanning across cache-lines,
but I am not sure that is the issue... (MR/MRL/MRM)
Can S5933 do them?

Any tips/suggestions?

Also, what is the suggested burst size under Linux for
such a NET device like mine? (cca. 2x 140 Mbps, MTU is 4470)


Thanks for in advance:
Gyuri


Gyorgy Horvath,        Technical University of Budapest
--------------         Dept. of Telecom. and Telematics

Tel.: +36-1-463-1865,  Fax.: +36-1-463-1865
Mail: horvaath@bme-tel.ttt.bme.hu
FTP:  ttt-pub.ttt.bme.hu  ./income