r8169 - dac testing (was: [mini-RFT] r8169 and amd64)

r8169 - dac testing (was: [mini-RFT] r8169 and amd64)

[Srihari Vijayaraghavan]

Hello Francois,

I read your email with a subject "[mini-RFT] r8169 and amd64" at LKML 
(archive). Since I am not subscribed to LKML I am unable to answer to that 
thread. Sorry.

Anyway, I have applied your patch at 
http://www.fr.zoreil.com/people/francois/misc/20041020-2.6.9-r8169.c-test.patch 
to vanilla 2.6.9, and tested it on my AMD64.

In its default configuration, ie, without use_dac=1 parameter, it works great. 
But OTOH with that parameter kernel displays these messages:

eth0: Identified chip type is 'RTL8169s/8110s'.
eth0: RTL8169 at 0xffffff0000040000, 00:0d:61:15:23:e6, IRQ 18
r8169: eth0: PCI error (cmd = 0x0017, status = 0x22b0).
eth1: link up, 100Mbps, full-duplex, lpa 0x45E1

And the network card does not work, as I cannot ping another host (DSL 
modem/router) on the network.

(Once I load the module with that parameter, unloading and reloading it 
without that parameter does not bring the network card back to its working 
configuration.)

Thank you.
Hari.

Re: r8169 - dac testing (was: [mini-RFT] r8169 and amd64)

[Francois Romieu]

Srihari Vijayaraghavan <sriharivijayaraghavan@yahoo.com.au> :
[...]
> r8169: eth0: PCI error (cmd = 0x0017, status = 0x22b0).
> eth1: link up, 100Mbps, full-duplex, lpa 0x45E1
> 
> And the network card does not work, as I cannot ping another host (DSL 
> modem/router) on the network.
> 
> (Once I load the module with that parameter, unloading and reloading it 
> without that parameter does not bring the network card back to its working 
> configuration.)

Thanks a lot.

- it does not crash but it did not recover;
- no difference with the newly reported PCI error under load on a 32bit host.

Bad mojo.

--
Ueimor
>