Re: [PATCH] Disable swsusp on CONFIG_HIGHMEM64

[Pavel Machek <pavel@ucw.cz>]

On Sat 07-01-06 16:04:03, Jan Spitalnik wrote:
> Dne pátek 06 leden 2006 00:43 Pavel Machek napsal(a):
> > On Fri 06-01-06 19:45:09, Jan Spitalnik wrote:
> > > Hello,
> > >
> > > suspending to disk is not supported on CONFIG_HIGHMEM64G setups
> > > (http://suspend2.net/features). Also suspend to ram doesn't work. This
> > > patch
> >
> > NAK. suspend2.net describes very different code.
> 
> Well, I was using suspend2.net's page just as reference, to point out the fact 
> that HIGHMEM is on both suspend "platforms" supported only up to 4G. 
> I was not refering to suspend2's actual features, but rather swsusp's 
> (or what's the proper name for suspend1 code). So i guess the patch still 
> holds, no?

No.

> > > fixes Kconfig to disallow such combination. I'm not 100% sure about the
> > > ACPI_SLEEP part, as it might be disabling some working setup - but i
> > > think that s2r and s2d are the only acpi sleeps allowed, no?
> >
> > s2ram probably works. Try getting it working without highmem64,
> > then turn it on.
> 
> It works with HIGHMEM but not HIGHMEM64G. You can find the oops from 
> HIGHMEM64G below. It crashes very reliably on little stress after resume.
> 

s2ram should not depend on ammount of memory. Try debugging
it, but do not disable feature just because it does not work
for you. I'd start with minimum drivers...

-- 
Thanks, Sharp!