HowTo crashkernel hibernation (was: [PATH 0/1] Kexec jump - v2 - the first step to kexec based hibernation)

HowTo crashkernel hibernation (was: [PATH 0/1] Kexec jump - v2 - the first step to kexec based hibernation)

[Al Boldi]

Pavel Machek wrote:
> > 3. Boot kernel compiled for normal usage, the reserved crash kernel
> > memory region must be added to kernel command line as following:
> >
> > crashkernel=<XX>M@<XX>M
> >
> > Where, <XX> should be replaced by the real memory size and
> > position.
>
> I used crashkernel=64M@64M .

It's good to see that people finally try this.

I used crashkernel=16M@16M, which is the absolute minimum I managed to have 
the crashkernel boot successfully.

> > 4. Load kernel compiled for hibernating usage as a crashdump kernel
> > with kexec, the same kernel as that of 3 can be used if
> > CONFIG_RELOCATABLE=y is selected.

That's not enough.  You have to set the CONFIG_PHYSICAL_START to 1,000,000 
for a 16M start.  That's because the crashkernel only supports vmlinux, 
which cannot be relocatable.

> > The kernel command line option as
> > following must be appended to kernel command line.
> >
> > kexec_jump_buf_pfn=`cat /sys/kernel/kexec_jump_buf_pfn`
> >
> > For example, the shell command line can be as follow:
> >
> > kexec -p /boot/vmlinux --args-linux --append="root=/dev/hdb signal
> > kexec_jump_buf_pfn=`cat /sys/kernel/kexec_jump_buf_pfn`"
>
> I think I followed the instructions closely. Now I'm trying to do
>
> kexec -p /data/l/linux/vmlinux --args-linux --append="init=/bin/bash
> kexec_jump_buf_pfn=`cat /sys/kernel/kexec_jump_buf_pfn`"
>
> but it tells me:
>
> Invalid memory segment 0x100000 - 0x7a0fff
>
> (and nothing in dmesg)
>
> If I try to load bzImage (corresponding to vmlinux I tried to use),  I
> get:
>
> root@amd:~# kexec -p /data/l/linux/arch/i386/boot/bzImage
> --append="init=/bin/bash \ kexec_jump_buf_pfn=`cat
> /sys/kernel/kexec_jump_buf_pfn`" Could not find a free area \ of memory of
> 9000 bytes... locate_hole failed
> root@amd:~#
>
> What am I doing wrong?

Nothing, but the doc isn't really clear on this, and an update is probably in 
order.


Thanks!

--
Al