Re: [PATCH 5/5 v2] ARM: OMAP1: recalculate loops per jiffy after dpll1 reprogram

[Janusz Krzysztofik <jkrzyszt@tis.icnet.pl>]

On Saturday 10 of December 2011 at 01:25:03, Russell King - ARM Linux wrote:
> On Fri, Dec 09, 2011 at 11:00:01AM +0100, Janusz Krzysztofik wrote:
> > 
> > Those were BogoMIPS, ...
> 
> I realise that.  But which is which - is 70.40 from recalibrate_delay
> or is it 74.54?  Your message is too vague to be able to interpret your
> results because it's impossible to work out what figure refers to which
> method.

Yes, I realised what you had actually asked about after re-reading your 
answer, which I unfortunately did after I had already replied, sorry.

> > ... Then, in case of a machine always booting at, let's say, 12 and
> > then reprogrammed to 150 MHz, we actually scale up that less then the
> > theoretical number, with a side effect of scaling up its error as well.
> > Perhaps in this case, when the machine is going to run at that target
> > rate until rebooted, we should rather decide to recalibrate to keep
> > that error proportionally small compared to the target loops per
> > jiffy value ...
> 
> It really doesn't matter - udelay() etc is not designed to be mega
> accurate but good enough... 

Great, that's the answer to my initial question: loops per jiffy 
inaccuracy of 6% shouldn't matter.

Thanks,
Janusz