Re: [PATCH v6 5/7] ARM: kirkwood: remove redundant DT board files

[Jason Cooper <jason@lakedaemon.net>]

On Wed, Jul 03, 2013 at 01:31:47PM +0200, Sebastian Hesselbarth wrote:
> On 07/03/13 01:09, Arnaud Ebalard wrote:
> >Hi Sebastian,
> >
> >Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com> writes:
> >
> >>With DT support for mv643xx_eth board specific init for some boards now
> >>is unneccessary. Remove those board files, Kconfig entries, and
> >>corresponding entries in kirkwood_defconfig.
> >
> >Applying above your set an old quilt cleaning patch Jason asked at some
> >point, it became empty except for arch/arm/mach_kirkwood/common.h in
> >which some declarations were left behind. If this is correct, can you
> >just merge the hunks below in your 5/7 in next round?
> >
> >AFAICT, only dnskw_init() remains, which matches the list of board-*.c
> >files in arch/arm/mach_kirkwood/ (i.e. board-dt.c and board-dnskw.c).
> 
> While updating the patch with yours, I stumbled upon MACH_TS219_DT that
> also remains because it includes tsx1x-common.c.
> 
> I cannot recall if Jason or Andrew said something about removing it..

board-ts219.c can be removed as well.  It needed a check for running on
the 6282 variant in order to set the phy address properly.  This can now
be handled in kirkwood-ts219-628[12].dts.

thx,

Jason.