From: Jason Cooper <jason@lakedaemon.net>
To: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com>
Cc: Thomas Petazzoni <thomas.petazzoni@free-electrons.com>,
Andrew Lunn <andrew@lunn.ch>,
Russell King <linux@arm.linux.org.uk>,
netdev@vger.kernel.org, linux-kernel@vger.kernel.org,
Gregory CLEMENT <gregory.clement@free-electrons.com>,
linux-arm-kernel@lists.infradead.org
Subject: Re: [PATCH v6 0/7] ARM: mvebu: switch to DT probed mv643xx_eth
Date: Thu, 25 Jul 2013 13:11:06 -0400 [thread overview]
Message-ID: <20130725171106.GM23879@titan.lakedaemon.net> (raw)
In-Reply-To: <1372762824-12202-1-git-send-email-sebastian.hesselbarth@gmail.com>
On Tue, Jul 02, 2013 at 01:00:17PM +0200, Sebastian Hesselbarth wrote:
> This patch set converts Marvell Dove, Kirkwood, and Orion5x DT enabled
> boards to probe mv643xx_eth by DT. The corresponding DT support patches
> for mv643xx_eth driver have already been taked by David Miller and are
> available in next-20130701. This only contains the ARM part of
> mv643xx_eth DT support patches and therefore patch counting is
> continued as v6 with respect to the combined patch set.
>
> The first three patches add nodes for ethernet-controller, mdio-bus,
> and ethernet PHYs found on the three SoCs and their boards.
>
> The last four patches convert DT boards for each SoC from platform_device
> registration to DT based probing by removing the corresponding calls.
> For Kirkwood this makes almost all DT board setup (except board-dnskw)
> obsolete. Therefore, patch 5 removes board setup files, Kconfig, Makefile,
> and defconfig entries for those boards.
>
> This patch set has been tested on Marvell Dove, and compile-tested for
> Kirkwood and Orion5x defconfig on top of next-20130701 with some fixes
> sent earlier applied (DMA_MEMSET fixes and missing include on edmini_v2).
>
> netdev is added on Cc for completeness, this is all Marvell related and
> should go through Jason Cooper's branch if there are no objections.
>
> Sebastian Hesselbarth (7):
> ARM: dove: add gigabit ethernet and mvmdio device tree nodes
> ARM: kirkwood: add gigabit ethernet and mvmdio device tree nodes
> ARM: orion5x: add gigabit ethernet and mvmdio device tree nodes
> ARM: dove: remove legacy mv643xx_eth setup
> ARM: kirkwood: remove redundant DT board files
> ARM: kirkwood: remove legacy clk alias for mv643xx_eth
> ARM: orion5x: remove legacy mv643xx_eth board setup
>
> arch/arm/boot/dts/dove-cubox.dts | 7 +
> arch/arm/boot/dts/dove.dtsi | 35 +++++
> arch/arm/boot/dts/kirkwood-cloudbox.dts | 16 ++
> arch/arm/boot/dts/kirkwood-db.dtsi | 16 ++
> arch/arm/boot/dts/kirkwood-dnskw.dtsi | 16 ++
> arch/arm/boot/dts/kirkwood-dockstar.dts | 17 ++
> arch/arm/boot/dts/kirkwood-dreamplug.dts | 28 ++++
> arch/arm/boot/dts/kirkwood-goflexnet.dts | 16 ++
> .../arm/boot/dts/kirkwood-guruplug-server-plus.dts | 30 ++++
> arch/arm/boot/dts/kirkwood-ib62x0.dts | 16 ++
> arch/arm/boot/dts/kirkwood-iconnect.dts | 16 ++
> arch/arm/boot/dts/kirkwood-iomega_ix2_200.dts | 24 +++
> arch/arm/boot/dts/kirkwood-is2.dts | 2 +
> arch/arm/boot/dts/kirkwood-km_kirkwood.dts | 16 ++
> arch/arm/boot/dts/kirkwood-lsxl.dtsi | 28 ++++
> arch/arm/boot/dts/kirkwood-mplcec4.dts | 27 ++++
> .../boot/dts/kirkwood-netgear_readynas_duo_v2.dts | 16 ++
> arch/arm/boot/dts/kirkwood-ns2-common.dtsi | 16 ++
> arch/arm/boot/dts/kirkwood-ns2.dts | 2 +
> arch/arm/boot/dts/kirkwood-ns2lite.dts | 2 +
> arch/arm/boot/dts/kirkwood-ns2max.dts | 2 +
> arch/arm/boot/dts/kirkwood-ns2mini.dts | 2 +
> arch/arm/boot/dts/kirkwood-openblocks_a6.dts | 16 ++
> arch/arm/boot/dts/kirkwood-sheevaplug-common.dtsi | 16 ++
> arch/arm/boot/dts/kirkwood-topkick.dts | 16 ++
> arch/arm/boot/dts/kirkwood-ts219-6281.dts | 4 +-
> arch/arm/boot/dts/kirkwood-ts219-6282.dts | 4 +-
> arch/arm/boot/dts/kirkwood-ts219.dtsi | 16 ++
> arch/arm/boot/dts/kirkwood.dtsi | 52 +++++++
> .../dts/orion5x-lacie-ethernet-disk-mini-v2.dts | 17 ++
> arch/arm/boot/dts/orion5x.dtsi | 29 ++++
> arch/arm/configs/kirkwood_defconfig | 22 ---
> arch/arm/mach-dove/board-dt.c | 9 -
> arch/arm/mach-kirkwood/Kconfig | 156 --------------------
> arch/arm/mach-kirkwood/Makefile | 23 +---
> arch/arm/mach-kirkwood/board-db88f628x-bp.c | 24 ---
> arch/arm/mach-kirkwood/board-dnskw.c | 7 -
> arch/arm/mach-kirkwood/board-dockstar.c | 32 ----
> arch/arm/mach-kirkwood/board-dreamplug.c | 35 -----
> arch/arm/mach-kirkwood/board-dt.c | 86 +-----------
> arch/arm/mach-kirkwood/board-goflexnet.c | 34 -----
> arch/arm/mach-kirkwood/board-guruplug.c | 33 ----
> arch/arm/mach-kirkwood/board-ib62x0.c | 29 ----
> arch/arm/mach-kirkwood/board-iconnect.c | 24 ---
> arch/arm/mach-kirkwood/board-iomega_ix2_200.c | 34 -----
> arch/arm/mach-kirkwood/board-km_kirkwood.c | 44 ------
> arch/arm/mach-kirkwood/board-lsxl.c | 36 -----
> arch/arm/mach-kirkwood/board-mplcec4.c | 35 -----
> arch/arm/mach-kirkwood/board-ns2.c | 35 -----
> arch/arm/mach-kirkwood/board-openblocks_a6.c | 26 ----
> arch/arm/mach-kirkwood/board-readynas.c | 27 ----
> arch/arm/mach-kirkwood/board-sheevaplug.c | 27 ----
> arch/arm/mach-kirkwood/board-ts219.c | 40 -----
> arch/arm/mach-kirkwood/board-usi_topkick.c | 29 ----
> arch/arm/mach-orion5x/edmini_v2-setup.c | 10 --
> 55 files changed, 520 insertions(+), 857 deletions(-)
> delete mode 100644 arch/arm/mach-kirkwood/board-db88f628x-bp.c
> delete mode 100644 arch/arm/mach-kirkwood/board-dockstar.c
> delete mode 100644 arch/arm/mach-kirkwood/board-dreamplug.c
> delete mode 100644 arch/arm/mach-kirkwood/board-goflexnet.c
> delete mode 100644 arch/arm/mach-kirkwood/board-guruplug.c
> delete mode 100644 arch/arm/mach-kirkwood/board-ib62x0.c
> delete mode 100644 arch/arm/mach-kirkwood/board-iconnect.c
> delete mode 100644 arch/arm/mach-kirkwood/board-iomega_ix2_200.c
> delete mode 100644 arch/arm/mach-kirkwood/board-km_kirkwood.c
> delete mode 100644 arch/arm/mach-kirkwood/board-lsxl.c
> delete mode 100644 arch/arm/mach-kirkwood/board-mplcec4.c
> delete mode 100644 arch/arm/mach-kirkwood/board-ns2.c
> delete mode 100644 arch/arm/mach-kirkwood/board-openblocks_a6.c
> delete mode 100644 arch/arm/mach-kirkwood/board-readynas.c
> delete mode 100644 arch/arm/mach-kirkwood/board-sheevaplug.c
> delete mode 100644 arch/arm/mach-kirkwood/board-ts219.c
> delete mode 100644 arch/arm/mach-kirkwood/board-usi_topkick.c
Applied whole series to mvebu/boards (v7 of #2 and #5)
thx,
Jason.
prev parent reply other threads:[~2013-07-25 17:11 UTC|newest]
Thread overview: 16+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-07-02 11:00 Sebastian Hesselbarth
2013-07-02 11:00 ` [PATCH v6 1/7] ARM: dove: add gigabit ethernet and mvmdio device tree nodes Sebastian Hesselbarth
2013-07-02 11:00 ` [PATCH v6 2/7] ARM: kirkwood: " Sebastian Hesselbarth
2013-07-07 20:34 ` [PATCH v7 " Sebastian Hesselbarth
2013-07-02 11:00 ` [PATCH v6 3/7] ARM: orion5x: " Sebastian Hesselbarth
2013-07-02 11:00 ` [PATCH v6 4/7] ARM: dove: remove legacy mv643xx_eth setup Sebastian Hesselbarth
2013-07-02 11:00 ` [PATCH v6 5/7] ARM: kirkwood: remove redundant DT board files Sebastian Hesselbarth
2013-07-02 23:09 ` Arnaud Ebalard
2013-07-02 23:29 ` Sebastian Hesselbarth
2013-07-03 11:31 ` Sebastian Hesselbarth
2013-07-03 14:33 ` Jason Cooper
2013-07-03 14:40 ` Jason Cooper
2013-07-03 16:57 ` [PATCH v7 " Sebastian Hesselbarth
2013-07-02 11:00 ` [PATCH v6 6/7] ARM: kirkwood: remove legacy clk alias for mv643xx_eth Sebastian Hesselbarth
2013-07-02 11:00 ` [PATCH v6 7/7] ARM: orion5x: remove legacy mv643xx_eth board setup Sebastian Hesselbarth
2013-07-25 17:11 ` Jason Cooper [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20130725171106.GM23879@titan.lakedaemon.net \
--to=jason@lakedaemon.net \
--cc=andrew@lunn.ch \
--cc=gregory.clement@free-electrons.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux@arm.linux.org.uk \
--cc=netdev@vger.kernel.org \
--cc=sebastian.hesselbarth@gmail.com \
--cc=thomas.petazzoni@free-electrons.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®